Denon DN-C630 user service English, “FadeIn OFF ***s”

ENGLISH

14)	“FadeIn OFF (***s)”
		FadeIn OFF (***s)	:	Set the fade in time. (*OFF/10 m/50 m/0.1/0.5/1/2)
15)	“Normal (+/–***%) Speed”
	*	Normal Speed	:	Play at normal speed.
		(+/–***%) Speed	:	Play at variable speed. ±(0.2/0.4/0.6/0.8/1.0/1.2/1.4/1.6/1.8/2.0/2.2/2.4/2.6/2.8/3.0)
16)	“Delay OFF (***ms)”
		Delay OFF (***ms)	:	Set the time for delayed start after the play start operation. (*OFF/100 m/200 m/300 m)
17)	“PlayLock ON (OFF)”
		PlayLock ON	:	Inhibit all operations other than the PLAY/PAUSE, TIME and PLAY MODE buttons during playback.
	*	PlayLock OFF	:	Enable all functions during playback.
18)	“FR Disp ON (OFF)”
	*	FR Disp ON	:	Display the frames on the time display during playback.
		FR Disp OFF	:	Do not display the frames on the time display during playback.
				(The frames are displayed in the manual search, standby, pause and end monitor modes.)
19)	“CD-R NO TOC ON (OFF)”
	*	Normal Disc	:	Play normal CD and CDR discs containing TOCs.
		No TOC Disc	:	Play CDR discs not containing TOCs.

NOTE:

For CDR discs without TOCs, there are no pits (signals) at the disc’s lead in and lead out sections, so errors may occur, particularly when searching for tracks. If an error should occur, open the disc holder, then close it and perform the operation again.

20)	“Remote EMA (INH)”
	*	Remote ENA	: Enable input of control signals to the parallel remote connector.
		Remote INH	:	Inhibit input of control signals to the parallel remote connector.
21)	“St. Tally ON (OFF)”
	*	St. Tally ON	: Output standby tally from parallel remote connector.
		St. Tally OFF	:	Do not output standby tally from parallel remote connector.
22)	“(******) Tally”
	*	INDEX 2 Tally	: Output index 2 tally signal to remote pin (17).
		INDEX 3 Tally	:	Output index 3 tally signal to remote pin (17).
23)	“Fader Pause (Play)”
	*	Fader Pause	: Start playback when remote fader pins (9-10) are short-circuited and pause when pins are open.
		Fader Play	: Start playback when remote fader pins (9-10) are short-circuited and continue playback when pins are
				open.
24)	“Stereo (Mono)”
	*	Stereo	: Output L and R stereo signals from the output connector.
		Mono	: Output mixed L and R signals from the output connector.
25)	“Preset Clr ? (Ini. Preset)”
		Preset Clr ?	: Clear the presettings (set to the initial factory values).
	*	Ini. Preset	: Do not clear the presettings.
26)	“Ver. xxxx”		:	Display the microprocessor version. (“xxxx” is a number.)

23