ENGLISH
@8PLAY MODE switch
•Use this to select the play mode.
•The play mode switch functions in the normal play, program play and random play modes.
SINGLE: (single track play mode)
The stop mode is set after one track is played. CONTINUE: (continuous play mode)
Playback continues on to the next track after one track is played.
NOTES:
•Repeat playback is not possible in the single mode.
•If the random play or programmed play mode is set in the single mode, random or programmed playback stops after one track.
@9OUTPUT SELECT switch
•This switches the output from the SELECTED/TUNER output terminal as follows:
SELECTED:
The sound of the tuner is output when the tuner is operated, the sound of the CD is output when the CD player is operated. When switched from the CD to the tuner, CD playback stops.
SEPARATE:
The sound of the tuner is always output, regardless of what is shown on the display or what is operated. In this mode, CD playback does not stop when the tuner is operated.
#0Remote Control Sensor (REMOTE SENSOR)
•This sensor receives the infrared light transmitted from the wireless remote control unit.
•This product does not come with a remote control unit.
#1Disc indicators (1 to 5)
•These indicate whether discs are loaded.
•All the indicators light green when the loading drawer is opened. When the loading drawer is closed, the tray spins, and if the set detects that no disc is loaded, the indicator for that disc number turns off.
#2Display
• Refer to page 11.
#3Headphones/display select button
•This button switches between the headphones output and the display.
•When the OUTPUT SELECT switch is set to the SEPARATE position, the headphones output and display switch to the CD when in the tuner mode, to the tuner when in the CD mode. When the OUTPUT SELECT switch is set to the SELECTED position the headphones output and display cannot be switched.
#4Tuner output adjustment control
(TUNER OUT ADJ)
•Use this to adjust the level of the tuner output from the SELECTED/TUNER and headphones output jacks.
•Even if the OUTPUT SELECT switch is set to the SELECTED position, this control only adjusts the tuner’s output level. It does not change the CD’s output level.
#5PHONES LEVEL control
• Use this to adjust the output level of the headphones.
#6Headphones jack (PHONES)
•For private listening, you can connect your headphones to this jack. Do not raise the volume level too much when listening through headphones.
#7Disc trays (1 to 5)
•One disc per tray can be loaded.
NOTE:
Do not stop the carousel by hand when it is turning. If this is done, the microprocessor erroneously determines the disc number and the disc can be damaged.
REAR PANEL
#8AM antenna terminals
(ANTENNA TERMINAL AM/GND)
•Connect the included AM loop antenna. (Refer to page 13 for connections.)
Connect with this terminal when a medium wave outdoor antenna is used.
#9FM antenna terminals
(ANTENNA TERMINAL FM)
•75 Ω /ohm coaxial cables can be connected to these terminals. For the connection procedure, see the section “CONNECTIONS”. (Refer to page 13.)
$0BALANCED OUT (CD) connectors
•These are active balanced outputs using XLR type connectors. The CD’s playback signals are output from these connectors.
•Pin layout: 1. Common
2.Cold
3.Hot
•Applicable connector: Cannon
common pin.
$1BALANCED OUT (SELECTED/TUNER) connectors
•These are active balanced outputs using XLR type connectors. The signal selected with the OUTPUT SELECT switch and the headphones/display select button is output from these connectors.
•Pin layout: 1. Common
2.Cold
3.Hot
•Applicable connector: Cannon
common pin.
$2UNBALANCED OUT (CD) terminals
•These are unbalanced outputs using RCA type terminals. The CD’s playback signals are output from these terminals.
10
