Denon English, 2Connecting the DN-H800to an Amplifier, 2Connection Precautions

ENGLISH

Leave your entire system (including the DN-H800) turned off until all connections between the DN-H800 and other components have

been completed.

2Connecting the DN-H800 to an Amplifier

•Before connecting the DN-H800 to your amplifier, it is a good practice to review your amplifier’s instruction manual.

•Use the white plugs for the left channel and red plugs for the right channel.

Receiver or amplifier

WHITE	CD	AUX WHITE	TUNER
L		L
R		R
RED		RED

DN-H800

WHITE	RED
	BALANCED OUT
L	R
CD	SELECTED
	/ TUNER
UNBALANCED OUT
CD	SELECTED
	/ TUNER
	REMOTE
ANTENNA TERMINALS
L R		Power supply
WHITE	RED	outlet

120 V 60 Hz

2Connection Precautions

•Before proceeding with connections or disconnections of cables and power cords, be sure to turn all system components off.

•Ensure that all cables are connected properly to the L (left) and R (right) jacks.

•Insert plugs fully into the terminals.

•Connect the CD output jacks to the amplifier CD or AUX input jacks.

2Wired remote control connections

•For wired remote control, use the circuit shown on the diagram below.

•Design the circuit so that the wire resistance is 0.5 Ω /ohms or less.

	C1
L ch	150	180	270	390	680	1.3k	3.9k
	N	N	N	N	N	N	N
		PRESET DOWN	PRESET UP				TUNER ON/OFF

		TUNER UNIT
C2
R ch	150	180	270	390	680	1.3k	3.9k
	N	N	N	N	N	N	N
	1	2	9	8	DISC SKIP
GND
C3		CD UNIT

R ch	G R L ø3.5mm
L ch		STEREO MINI PLUG
GND

*1 N 6 (“N” is the number of DN-H800 units connected.)

•Up to six units can be controlled simultaneously with one remote control unit.

•Wire the signal and ground lines as shown on the diagram below and connect at the remote control inputs (C1, C2 and C3).

•Design the circuit so that the resistance of the individual wires is 0.5 Ω /ohms or less.

Connecting two DN-H800 units (N = 2)

Remote unit

C1 C2 C3

DN-H800

1

2Installation Precautions

DN-H800

2

•If the DN-H800 is placed near amplifier, tuner or other components, noise (induced hum) or beat interference may result (especially during AM or FM reception).

If this occurs, separate the DN-H800 from other components or reorient its position.

NOTE:

Use this unit in a horizontal orientation.

When the unit is used with the front panel facing upward (and the unit is in a vertical orientation) or when the front panel is on an incline, the will not operate properly.

14