
ENGLISH
6ROTATING INPUT SELECT SWITCHES
About the Cables
1.Disconnect the power.
2.Remove knobs from the top panel.
3.Remove the 6 screws attaching the top panel.
4.Remove the 2 screws attaching the switch unit.
5.Rotate the switch unit to the desired location.
6.Reinstall the 2 screws holding the switch unit.
7.Reinstall the top panel and reattach knobs.
NOTE:
•Only the knob for CUE SELECT is different.
(For RCA in/out jack)
| Cable 1 |
(For SEND/RETURN) |
|
Unbalanced (1/4” TS) | Cable 2 |
(For BALANCED MASTER OUT)
Balanced (1/4” TRS) | Cable 3 |
Sleeve=GND |
|
Ring=Cold |
|
Tip=Hot |
|
(For MIC) |
|
Balanced (1/4” TRS) | Cable 4 |
RCA pin plug
Unbalanced
Unbalanced (1/4” TS)
Balanced (1/4” TRS)
Sleeve=GND
Ring=Cold
Tip=Hot
Balanced 1=GND
Switch unit
Sleeve=GND
Ring=Cold
Tip=Hot
(For BALANCED MASTER OUT)
2=Hot
3=Cold
2=Hot 1=GND | Balanced | Cable 5 |
| ||
|
|
3=Cold
(For MIC EFFECT LOOP)
Adaptor R=Ring
Cable 6
L=Tip
Balanced (1/4” TRS)
Sleeve=GND
Ring=Cold
Tip=Hot
Balanced (1/4” TRS)
Sleeve=GND
Ring=R
Tip=L
10