2BEFORE USING
Read the following before using the set.
• Before turning on the power |
Check again that all connections are correct and that |
there are no problems with the connection cords. Be |
sure to unplug the power cord before connecting or |
disconnecting the connection cords. |
• Moving the set |
To prevent |
•Store this instructions in safe place
After reading, store this instructions along with the warranty in a safe place. Also fill in the items on the back paper for your convenience.
•Illustrations in this manual
Note that some of the illustrations used for explanations in this manual may differ from the actual set.
Installing an AM outdoor antenna |
| Connecting an FM outdoor antenna |
| ||
Connect the signal wire from the AM outdoor antenna to | If good reception cannot be achieved with the included | ||||
the antenna terminal. Be sure to connect the signal | FM antenna, use an FM outdoor antenna. Connect an IEC- | ||||
type connector to the coaxial cable and connect the | |||||
ground wire to the | terminal. Also be sure to connect | ||||
antenna to the FM COAX (75 Ω/ohms) terminal. | |||||
the included AM loop antenna.
cords, always unplug the power cord and disconnect |
the connection cords between all other audio |
components when moving the set. |
AM LOOP ANT.
ANTENNA
Selecting a place for the FM outdoor antenna
• Set the antenna so that it points towards the broadcast |
station’s transmitting antenna. Behind buildings or |
mountains, set the antenna in the position at which |
reception is best, and also try changing the direction of |
the antenna. |
• Do not install the antenna under power lines. |
Doing so is extremely dangerous, as the power line |
3CONNECTING THE ANTENNAS
could touch the antenna. |
• Install the antenna away from roads or train tracks to |
avoid noise from cars or trains. |
Installing the FM indoor antenna
Tune in FM station (see page 13), set the antenna so that distortion and noise is minimal, then secure the tip of the antenna in this position using tape or a pin.
AM loop antenna
Installing the AM loop antenna
Tune in an AM station (see page 13) and set the antenna as far from the system as possible to keep distortion and noise is minimal. In some cases, it is best to invert the polarities. AM broadcasts cannot be received well if the loop antenna is not connected or if it is set close to metal objects.
Assembling the AM loop antenna
AM loop antenna | AM outdoor antenna | ||
|
|
|
|
Signal ground
• Do not install the antenna too high, as it may be hit by |
lightning. |
FM antenna
FM COAX. | AM LOOP ANT. |
75 |
|
ANTENNA
12
Remove the vinyl tie and take out the connection line.
4
a. With the antenna on top any stable surface.
Mount
b. With the antenna attached to a wall.
Connect to the AM antenna terminals.
3
Bend in the reverse direction.
Installation hole Mount on wall, etc.
5