Speaker Connections
Subwoofer |
|
|
|
|
|
|
| Speaker | (Supplied) | ||||
with |
| |||||
|
|
|
|
|
| |
|
|
|
|
|
| |
amplifier |
|
|
|
|
| |
|
|
|
|
| ||
| (R) | (L) |
*/ | w q | w q |
Connecting the Speaker Cables
Check the left (L) and right (R) channels and the + (red) and – (black) terminals on the set and the speakers to be used and interconnect the cables to the same polarities.
1Peel off about 10 mm of the sheathing at 
the tip of the cable, twist the core wire and 
terminate it.
2Turn the speaker terminal counterclockwise
to loosen it.
3Insert the speaker cable’s core wire into the base of the speaker terminal.
4Turn the speaker terminal counterclockwise
to tighten it.
When using a banana plug
Tighten the speaker terminal firmly before inserting the banana plug.
ENGLISH
NOTE | Getting | ||
• Use speakers with an impedance of 6 to 16 Ω/ohms. The protection | |||
| |||
circuit may be activated if speakers with an impedance other than | Started | ||
specified are used. | |||
| |||
• Connect the speaker cables in a way that they do not stick out of the |
| ||
speaker terminals. The protection circuit may be activated if the core |
| ||
Connections | |||
wires touch the rear panel or screws or if the + and – sides touch. | |||
| |||
• Never touch the speaker terminals while the power is on. Doing so |
| ||
could cause electric shock. |
| ||
|
|
| |
Protector circuit |
| Setup | |
The protection circuit will be activated in the following cases: |
| ||
• When the speaker cable's core wires are touching the rear |
| Playback | |
panel or screws or when the speaker cable’s + and – sides are |
| ||
|
| ||
touching |
|
| |
• When the surrounding temperature is extremely high |
|
| |
• When the internal temperature rises due to extended use with a |
| Setting | |
high output |
| ||
|
| ||
If this happens, unplug the power cord, then check the connections |
| the | |
of the speaker cables and input cables. If the set’s temperature |
| ||
is extremely high, wait for it to cool off and improve surrounding |
| Timer | |
ventilation. After doing this, plug the power cord back in. |
| ||
If the protection circuit is activated though there are no problems |
| Other | |
in ventilation around the set or in connections, the set could be |
| ||
damaged. Turn off the power, then contact a DENON servicing and |
| ||
inquiry outlet. |
| Functions | |
|
| ||
|
| Troubleshooting | |
|
| Specifications | |
|
|
| |