NOTE

•Discs with special shapes (heart-shaped discs, octagonal discs, etc.) cannot be played. Do not attempt to play them, as doing so can damage the product.

•Some discs and some recording formats may not be playable.

•Non-finalized discs cannot be

played.

b What is finalization? Finalization is the process that

makes recorded CD-R/CD-RW discs playable on compatible players.

Holding Discs

Do not touch the signal surface.

•“00 Tr 00 : 00” is displayed if a disc that cannot be played is loaded.

•“00 Tr 00 : 00” is displayed if the disc is loaded upside-down or if no disc is loaded.

NOTE

Do not push the disc tray in by hand when the power is turned off. Doing so could damage the set.

Cautions on Loading Discs

•Only load one disc at a time. Loading two or more discs can damage the unit or scratch the discs.

•Do not use cracked or warped discs or discs that have been repaired with adhesive, etc.

•Do not use discs on which the sticky part of cellophane tape or labels is exposed or on which there are traces of where labels have been removed. Such discs can get caught inside the player and damage it.

ENGLISH

Cleaning Discs

 

Getting

• If there are fingerprints or dirt on discs, wipe them off before using

Started

the disc. Fingerprints and dirt can impair sound quality and cause

interruptions in playback.

 

• Use a commercially available disc cleaning set or a soft cloth to clean

Connections

discs.

 

 

 

 

 

Setup

 

 

Playback

Gently wipe the disc from the

Do not wipe with a circular

Setting

inside towards the outside.

motion.

NOTE

 

 

the

Do not use record spray, antistatic agents, or benzene, thinner or other

Timer

solvents.

 

 

 

Loading Discs

•Set the disc with the labeled side facing up.

•Make sure the disc tray is fully open when inserting the disc.

•Place the discs flatly, 12 cm discs in the outer tray guide (Figure 1), 8 cm discs in the inner tray guide (Figure 2).

Figure 1

Figure 2

Outer tray guide

Inner tray guide

12 cm disc

8 cm disc

•Place 8 cm discs in the inner tray guide without using an adapter.

Cautions on Handling

•Do not get fingerprints, oil or dirt on discs.

•Take special care not to scratch discs when removing them from their cases.

•Do not bend or heat discs.

•Do not enlarge the hole at the center.

•Do not write on the labeled (printed) surface with ball-point pens, pencils, etc., or stick new labels on discs.

•Water droplets may form on discs if they are moved suddenly from a cold place (outdoors for example) to a warm place, but do not try to dry them off using a hairdryer, etc.

Cautions on Storing Discs

•Be sure to remove discs after using them.

•Be sure to store discs in their cases to protect them from dust, scratches, warping, etc.

•Do not store discs in the following places:

1.Places exposed to direct sunlight for long periods of time

2.Dusty or humid places

3.Places exposed to heat from heating appliances, etc.

About the Remote Control Unit

Other

Functions

Inserting the Batteries

Troubleshooting

q Slide the rear lid in the w Load the two batteries properly

direction of the arrow and

as indicated by the marks in the

remove it.

battery compartment.

 

 

 

 

Specifications

ePut the rear cover back on.