6
1.5 Communicating via the Optical In-terface■ Optical Communications with the BHT-7000
The BHT-7000 communicates using an IR beam, so make sure that there is no obstruc-
tion in the light path between the BHT-7000 and any target stations.
In the IrDA communications mode, you need to keep the BHT-7000 and any target
stations within the effective light emission range, usually 10 to 80 cm (3.94 to 31.50'').
■ Communicating with the CU-7000
The optional CU-7000 is an IrDA-compliant communications unit. For optical commu-
nications, put the BHT-7000 directly on the CU-7000 as shown below.
■ Communicating with other IrDA-compliant equipment
You can also have the BHT-7000 communicate with other IrDA-compliant equipment
just by aligning their IR ports with each other. The effective IR range and IR port angle
may differ depending upon the target equipment, so observe the instructions given in
manuals furnished with such equipment.
If transfer using the BHT-7000 fails, bring it closer to the target station or change the IR
port angle, and try again.
Communications failures might be caused by highly intensive light emitted from
ceiling (inverter-driven fluorescent) lamps or direct sunlight. Take care to prevent
such interference light from coming into the optical interface ports of the BHT-
7000 and IrDA-compliant equipment, including the CU-7000.
Do not use any TV remote control in the vicinity of the IR communications system.
Doing so may interfere with the communications.
NOTE
NOTE