OWNER’S MANUAL
INSTALLATION
Continued
INSTALLING LOGS
WARNING: Failure to posi- tion the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in prop- erty damage or personal injury.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Place front log (#1) on top of the grate. Make sure the notches in the bottom of the log fits over the grate prongs (see Figure 16). Push back of logs flush with metal grate bar.
2.Rest middle log (#2) behind metal posts on front burner. Make sure the grooves in the bottom of the log fit over the grate. Bring the log forward next to the metal posts. The
3.Slide the grooves in the back of the rear log (#3) against the rear grate prongs. Make sure the peg on the log is on top (see Figure 18).
4.Place the crossover log (#4) on the back log and the middle log. Make sure the peg on the rear log is in the hole in the bottom of the crossover log. The cross- over log should fit in the cutout of the middle log (see Figure 19).
Notch
Front Log (#1)
Grate
Prongs
Metal Grate Bar
Figure 16 - Installing Front Log (#1)
Middle Log (#2)
Groove
Metal Post
Groove
Metal Post | Grate |
Figure 17 - Installing Middle Log (#2)
Groove in | Rear Log (#3) |
Back of Log | Peg |
| Groove |
| in Back |
Grate Prong | of Log |
| |
Rear |
|
Burner |
|
| Grate |
| Prong |
Figure 18 - Installing Rear Log (#3)
Crossover
Log (#4)
Hole
Cutout
Peg
Figure 19 - Installing Crossover Log (#4)
104414 | 13 |