INSTALLATION
Continued
VENTILATION
OPERATION
6
3.Connect hose to inlet connector. Tighten fi rmly using a wrench.
IMPORTANT: Use extra hose or piping if needed. Install extra hose or piping between hose/regulator assembly and propane tank. You must use the regula- tor supplied with heater.
Inlet Connector | Hose |
Figure 4 - Hose and Inlet Connector
4.Open propane supply valve on propane tank(s).
5.Check all connections for leaks. Apply mixture of liquid soap and water to gas joints. Bubbles forming show a leak that must be corrected.
!WARNING
Never use an open flame to check for a leak. Apply a mixture of liquid soap and water to all joints. Bubbles forming show a leak that must be corrected. Correct all leaks at once.
6. Close propane supply valve.
!WARNING
Provide proper ventilation. If proper fresh, outside air ventila- tion is not provided, carbon monoxide poisoning can occur. Provide two fresh, outside air openings for ventilation. One opening should be near the floor, the other opening near the ceiling. Each ventilation opening must be at least 130 cm2. Provide proper fresh, outside air ventilation before running heater.
!WARNING
Review and understand the warnings in the Safety Informa- tion section, pages 2 and 3. They are needed to safely oper- ate this heater. Follow all local codes when using this heater.
To Start Heater
1.Follow all installation, ventilation, and safety information.
2.Locate heater on stable and level surface. Make sure strong drafts do not blow into front or rear of heater.
3.Plug heater power cord into electrical source. Motor will start. Fan will turn, forcing air out front of heater.
4.Open propane supply valve on propane tank(s).
