OWNER’S MANUAL
INSTALLATION
Continued
Dual Burner Premium Aged Split Oak Models
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Place the base of the middle log (#1) in the
2.Locate pegs on the bottom of back log (#2). Slide these pegs into the holes in the grate base behind the burner (see Figure 23).
3.Place crossover log (#3) onto the pin (right) on middle log (#1) and into the recess of the back log (#2). See Figure 24.
Middle Log (#1)
Tab
Burner
“U” Bend
Slot
Figure 22 - Installing Middle Log (#1)
4.Locate the notches in the bottom of the front log (#4). Place the front log on the grate fingers. Make sure the notches of the front log line up with the grate fingers. See Figure 25.
5.With knot to right side, place smaller log piece (#5) over the pin on the left side of the middle log. The smaller log will rest on front log against the "knot" on the left. See Figure 26.
6.Place lava rock around base of heater. Do not put lava rock on logs on burner.
Back Log (#2)
Hole in
Grate Base
Peg
Burner
Figure 23 - Installing Back Log (#2)
Crossover Log (#3)
Recess
Peg
Figure 24 - Installing Crossover Log (#3)
Front Log (#4)
Notches
Grate Fingers
Figure 25 - Installing Front Log (#4)
Log Piece (#5)
Peg
Figure 26 - Installing Log Piece (#5)
Continued
104340 | 15 |