INSTALLATION
Continued
Single Burner Mountain Oak Models
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Place the back log (#1) onto the back of the burner. Make sure the log sits down into the hole in the grate and leans forward onto the two posts in front of the log (see Figure 27).
2.Locate the notches on the underside of the front log (#2). Also notice the re- cesses on the back of log #2. Slide the notches over the tabs on the grate base and the front posts into the recesses on the back (see Figure 28).
3.Place the crossover log (#3) on top of the back log and front log. Make sure the crossover log is seated into the notches on top of the back and front logs (see Figure 29).
4.Add lava rock around base of heater. Do not put lava rock on logs or burner.
Back Log (#1)
Hole in
Grate
Post
Figure 27 - Installing Back Log
Front Log
(#2)
Recess
Notch
Tabs on | Post |
Grate Base |
|
Figure 28 - Installing Front Log
Crossover
Log (#3)
Notch
Notch
Figure 29 - Installing Crossover Log
16 | 104340 |