Desa CDR3924PT installation manual Gas leak. See Warning

TROUBLESHOOTING

Continued

WARNING: If you smell gas

•Shut off gas supply.

•Do not try to light any appliance.

•Do not touch any electrical switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Fol- low the gas supplier’s instructions.

•If you cannot reach your gas supplier, call the fire department.

IMPORTANT: Operating heater where impurities in air exist may create odors. Cleaning supplies, paint, paint remover, cigarette smoke, cements and glues, new carpet or textiles, etc., create fumes. These fumes may mix with combustion air and create odors. These odors will disappear over time.

OBSERVED PROBLEM POSSIBLE CAUSE REMEDY

Heater produces unwanted 1.	Heater burning vapors from
odors	paint, hair spray, glues, clean-
	ers, chemicals, new carpet,
	etc. (See IMPORTANT state-
	ment above)
2.	Low fuel supply (propane/LP
	only)
3.	Gas leak. See Warning
	statement at top of page

1.Open window to ventilate room. Stop using odor caus- ing products while heater is running

2.Refill supply tank (propane/ LP only)

3.Locate and correct all leaks (see Checking Gas Connec- tions, page 13)

Heater shuts off in use (ODS	1. Not enough fresh air is avail-		1.	Open window and/or door for
operates)		able		ventilation
	2.	Low line pressure	2.	Contact local natural or pro-
	3.	ODS/pilot is partially		pane/LP gas company
			3.	Clean ODS/pilot (see Cleaning
		clogged		and Maintenance, page 19)
Gas odor even when control knob	1. Gas leak. See Warning		1.	Locate and correct all leaks
is in OFF position		statement at top of page		(see Checking Gas Connec-
	2.	Control valve defective		tions, page 13)
			2.	Replace control valve

Gas odor during combustion	1.	Foreign matter between con-
		trol valve and burner
	2.	Gas leak. See See Warn-
		ing statement at top of
		page

1.Take apart gas tubing and remove foreign matter

2.Locate and correct all leaks (see Checking Gas Connec- tions, page 13)

Log set cycles to pilot, but room	1. Thermostat sensing bulb	1. Reposition thermostat sensing
temperature drops to a lower than	needs to be repositioned	bulb (see Optional Position-
ideal level before log set comes		ing of Thermostat Sensing
back on		Bulb, page 24)

113183-01A www.desatech.com 23