ASSEMBLY
Continued
ASSEMBLING FIREPLACE
Tools Required: Phillips screwdriver, 5/16" hex wrench, and slotted screwdriver
Installing Log
1.Remove back log, branch, and hood from log box. Discard protective packaging.
2.Remove two shipping screws above screen (see Figure 2).
3.Lift screen up and pull out to remove.
4.An optional blower is available. See Accessories, page 32. Install optional blower now. Follow installation instructions provided with blower.
5.Gently place back log on burner support (see Figure 2). The log should fit flat against top of burner support. Place two #10
6.Reattach screen by placing notches in screen frame over shoulder screws and
pushing down.
| Screen Shipping Screw |
Back Log | Shoulder Screw |
| |
| Burner |
Screw | Support |
| Branch |
| Support |
Screen | Screw |
| |
| Branch |
Figure 2 - Assembling Fireplace | |
WARNING ICONG 001WARNING |
Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this fireplace may result in property damage or personal injury.
Assembling Hood
1.Lift screen off heater.
2.Remove two
Upper
Louver
Assembly
2 Short
Screws
Figure 3 - Assembling Hood
3. Pull louver assembly straight out from the cabinet. Be careful not to scratch the paint. Set louver assembly and screws aside.
4. Locate two black Phillips sheet metal screws from the hardware packet.
5. Place hood over top edge of firebox wrapper.
6. Attach hood with two short screws in center of hood.
7. Replace upper and lower assembly and
5
103667