Desa CGD3924NR installation manual Operating

OPERATING			TO TURN OFF GAS TO APPLIANCE
HEATER	Shutting Off
			Heater
	1.	Turn control knob clockwise		to the OFF position.
Continued 2.		Set remote selector switch in the OFF position to keep from draining battery.
	Shutting Off Burners Only (pilot stays lit)
	You may shut off the burners and keep the pilot lit by doing one of the following:

•Turn control knob clockwise to the PILOT position.

•Use remote control manual OFF button.

•Set remote selector switch in the OFF position.

THERMOSTAT CONTROL OPERATION

The thermostat control setting on the remote control unit can be set to any comfort level between HI and LO. The Burners will turn on and off automatically to maintain the comfort level you select. The ideal comfort setting will vary by household depending upon the amount of space to be heated, the output of the central heating system, etc.

MANUAL LIGHTING PROCEDURE

1.Follow steps 1 through 6 under Lighting Instructions, pages 19 and 20.

2.Depress control knob and light pilot with match.

3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow step 9, page 20.

HAND HELD REMOTE OPERATION

NOTICE

You must light the pilot before using the hand-held remote control unit. See

Lighting Instructions on page 19.

Flame Adjustment Knob	Control Knob in On Position
IH			IL
ON		F	P	O
	O			T
OFF				O
				N
REMOTE
LO

Remote Selector Switch in Remote Position

Figure 21 - Setting the Remote Selector Switch, Control Knob, and Flame

Adjustment Knob for Remote Operation

1.After lighting, let pilot flame burn for about one minute. Turn control knob to ON position. Adjust flame adjustment knob anywhere between HI and LO. Slide the remote selector switch to the REMOTE position. The burners will come on. You can now turn the burners on and off with the hand-held remote control unit.

IMPORTANT: Do not leave the remote selector switch in the REMOTE position when the pilot is not lit. This will drain the battery.

2.Select the MANUAL or AUTO button on the hand-held remote control unit.

•In MANUAL mode, turn burners on or off by pressing the ON or OFF buttons on the hand-held remote control unit.

•In AUTO mode, the room temperature is controlled by the thermostat in the hand-held remote control unit. To increase the room temperature, press the top arrow of the TEMP button. To lower room the temperature, press the bottom arrow to the TEMP button. At higher settings the heater will run more.

IMPORTANT: The hand-held remote control unit must be near the heater. Do not

keep the hand-held remote control unit too close the heater. The thermostat on
the hand-held remote control unit will heat up too quickly and turn the heater
off.	Continued 21

103343