CGFP28N and CGFP28NT
UNVENTED
INSTALLATION
Continued
INSTALLING GA3650T
BLOWER ACCESSORY
(For CGFP28PT Model Only)
NOTICE:
1.Remove fireplace screen (see Figure 15).
WARNING: You must operate this fireplace with the fireplace screen in place. Make sure fire- place screen is in place before running fireplace.
2.If logs are installed, carefully remove the logs and set aside, noting the prop- erly mounted location of each.
3.Remove screws that attach log base as- sembly to fireplace. Carefully lift up log base assembly and remove from fire- place, taking care to pull flexible gas line through the access holes (see Figure 16).
CAUTION: Do not pick up log base assembly by burners. This could damage burners. Only handle base by grates.
4.Attach power cord to blower motor by firmly pushing the two female termi- nals of the power cord onto the two spade terminals on blower motor. Us- ing screw provided, attach ringed ter- minal of power cord to mounting tab of blower housing (see Figure 17). Tighten screw securely.
5.Place the blower against lower rear wall of firebox outer wrapper with the ex- haust port directed upward. Align the holes in top mounting tabs of blower with holes in wall of wrapper (see Fig- ure 17). Using 2 screws provided, mount blower and tighten screws securely.
6.Be certain that all wire terminals are securely attached to terminals on blower motor and that the screw retain- ing the green ground wire is tight.
7.Place control knob provided on plastic control shaft of speed control.
8.Mount the speed control on the front leg of the left floor support bracket us- ing 2 screws provided (see Figure 18).
Notches
Screen Mounting Screws
Figure 15 - Removing Fireplace Screen
Flexible
Gas Line
Screws
Log Base
Figure 16 - Removing Log Base from Fireplace
Lower
Rear Wall
of Firebox
Blower
Screws
Exhaust Port
Power Cord
Figure 17 - Mounting Blower to Firebox
Left Floor
Support
Bracket
Screws
Speed
Control
Control
Control Shaft
Knob
Figure 18 - Attaching Speed Control to Firebox
10 | 103413 |
