OWNER’S MANUAL
INSTALLATION
Continued
INSTALLING LOGS
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
CAUTION: Do not remove the metal data plates attached to the heater base assembly. The data plates contain important warranty information.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Slide rear log (#1) into place behind rear burner. Make sure flat areas at bot- tom of log are behind rear burner (see Figure 16).
2 . Slide bottom middle log (#2) into place in behind front burner. Make sure tabs at bottom of log are behind front burner (see Figure 17).
3.Place front log (#3) into place in front of bottom middle log (#2) (see Figure 18). Make sure notches on bottom rest on grate prongs.
4.Finally place top log (#4) over bottom middle log (#2) by matching the notches under log (#4) with the raised blocks of log (#2) (see Figure 19).
Rear Log (#1)
Figure 16 - Installing Rear Log
Bottom Middle Log (#2)
2
Tab
Figure 17 - Installing Bottom Middle Log
3
Front Log (#3)
Figure 18 - Installing Front Log
Top Log (#4)
4 
4
Figure 19 - Installing Top Log
103424 | 13 |
