Preparing for use
Installing the software
►During installation, follow the instructions on screen.
Consult the operating system manual if there is anything unclear about the requested input data.
i | You will find further information about the system, drivers, utilities, updates, manuals etc. |
on the "Drivers & Utilities" CD supplied. |
Connecting external devices
Read the documentation on the external device before connecting it. The power plug must ! be removed before connecting external devices, apart from USB devices.
Do not either connect or disconnect cables during storms.
Always take hold of the actual plug. Never unplug a cable by pulling the cable itself. Connect and disconnect the cables in the order described below.
Connecting cables
●Turn off all power and equipment switches.
●Remove all power plugs from the mains outlets.
●Connect all cables at the workstation and peripherals. Under all circumstances, please observe the safety notes provided in the "Important notes" chapter.
●Plug all data communication cables into the utility sockets.
●Plug all power cables into the grounded mains outlets.
Disconnecting cables
●Turn off all power and equipment switches.
●Remove all power plugs from the mains outlets.
●Unplug all data communication cables from the utility sockets.
●Disconnect all cables from the workstation and peripherals.
USB devices are
i and disconnected with the system switched on.
Additional information can be found in the "Connecting external devices to the USB ports" section and in the documentation for the USB devices.
11 |
