TROUBLE- | OBSERVED | POSSIBLE |
|
|
| ||
PROBLEM | CAUSE | REMEDY | |||||
SHOOTING | |||||||
|
|
|
|
|
| ||
When control knob is | 1. Gas supply turned off | 1. | Turn on gas supply or | ||||
Continued | |||||||
| pressed in and turned |
| or manual shutoff |
| open manual shutoff | ||
| to the PILOT/IGN |
| valve closed |
| valve | ||
| position, there is | 2. | Control knob not | 2. | Press in control knob | ||
| spark at ODS/pilot |
| pressed in while being |
| while turning to | ||
| but no ignition |
| turned to PILOT/IGN |
| PILOT/IGN position | ||
|
|
| position |
|
|
| |
|
| 3. | Air in gas lines when | 3. | Continue holding down | ||
|
|
| installed |
| control knob. Repeat | ||
|
|
|
|
| igniting operation until | ||
|
|
|
|
| air is removed | ||
|
| 4. | Depleted gas supply | 4. | Contact local propane/ | ||
|
|
|
|
| LP gas company. | ||
|
| 5. | ODS/pilot is clogged | 5. | Clean ODS/pilot (see | ||
|
|
|
|
| Cleaning and Mainte- | ||
|
|
|
|
| nance, page 22) or | ||
|
|
|
|
| replace ODS/pilot | ||
|
|
|
|
| assembly | ||
|
| 6. | Gas regulator setting is | 6. | Replace gas regulator | ||
|
|
| not correct |
|
|
| |
|
|
|
|
|
|
| |
| ODS/pilot lights but | 1. | Control knob not fully | 1. | Press in control knob | ||
| flame goes out when |
| pressed in |
| fully | ||
| control knob is | 2. | Control knob not | 2. | After ODS/pilot lights, | ||
| released |
| pressed in long enough |
| keep control knob | ||
|
|
|
|
| pressed in 10 seconds | ||
|
| 3. | Manual shutoff valve | 3. | Fully open manual | ||
|
|
| not fully open |
| |||
|
| 4. | Thermocouple connec- | 4. | Hand tighten until | ||
|
|
| tion loose at control |
| snug, then tighten 1/4 | ||
|
|
| valve |
| turn more | ||
|
| 5. | Pilot flame not touch- | 5. | A) Contact local | ||
|
|
| ing thermocouple, |
| propane/LP gas | ||
|
|
| which allows thermo- |
| company | ||
|
|
| couple to cool, causing |
|
|
| |
|
|
| pilot flame to go out. |
| B) Clean ODS/pilot | ||
|
|
| This problem could be |
| (see Cleaning and | ||
|
|
| caused by one or both |
| Maintenance, page 22) | ||
|
|
| of the following: |
| or replace ODS/pilot | ||
|
|
| A) Low gas pressure |
| assembly | ||
|
|
| B) Dirty or partially |
|
|
| |
|
|
| clogged ODS/pilot |
|
|
| |
|
| 6. | Thermocouple dam- | 6. | Replace thermocouple | ||
|
|
| aged |
|
|
| |
|
| 7. | Control valve damaged | 7. | Replace control valve |
Continued
101827
23