Desa CHDV41N/P Wireless Hand-Held Remote Control, Removing/Replacing Glass Door, Owner’S Manual

OWNER’S MANUAL

FIREPLACE INSTALLATION

Continued

WIRELESS HAND-HELD REMOTE CONTROL

(Included)

Installing Battery into Receiver

1.Open bottom louver and locate the switch bracket on the left.

2.Unscrew the switch bracket. Lean bracket forward so you are able to ac- cess the back of the remote receiver.

3.Locate the battery clip mounted on the back of the receiver. Slide a 9-volt bat- tery (not included) through the clip.

4.Attach the terminal wires to the battery.

5.Replace the switch bracket.

Receiver

Terminal

Wires

Battery Clip

9-Volt Battery

Figure 40- Attaching Battery to Receiver

Installing 9-Volt Battery in Hand- Held Remote Control Unit

REMOVING/REPLACING GLASS DOOR

You must remove glass door to install op- tional brick liners, logs, lava rock, and em- ber material.

CAUTION: Do not operate this fireplace with a broken glass door panel or without the glass door panel securely in place. For re- placement part information see Replacement Parts, page 31.

Top Louver

Panel

Figure 42 - Removing Top Louver Panel

1.Remove the upper louver panel by lift- ing upward and out (see Figure 42).

2.Remove the screws from the three tabs at the top of the glass door while hold- ing door securely keeping it from fall- ing forward.

3.Grasp door by both sides and ease it upward off of the lower bracket (see Figure 43).

4.To replace glass door, follow the above instructions in reverse.

1.Remove battery cover on back of re- mote control unit.

2.Attach terminal wires to a 9-volt bat- tery (not included). Place battery into the battery housing.

3.Replace battery cover onto remote con-

trol unit.

	Battery
Terminal	Cover	Remote
Wires		Control Unit
9-Volt
Battery
		Battery
		Housing

Figure 41 - Installing Battery in Hand- Held Remote Control Unit

Screw

Glass

Door

Assembly

Lower Bracket for

Glass Door Assembly

Figure 43 - Removing/Replacing Glass Door Continued

105542 21