Mounting Screw s |
Rubber Gasket |
Identification Label |
Figure 38 - Installing Pressure Regulator Assembly |
FINAL PREPARATION
1.Place the grate and log assembly back into position on the grate stand as shown in your appliance Installation Manual.
2.Close the glass door and tightly secure all four latches.
3.Replace the screen rod assembly and then the top and bottom louver assemblies with the louvers pointing down. The upper louver should have the brass strip on the bottom and the bottom louver should have the brass strip on top.
The conversion is now Complete.
Refer to the section on Gas Supply Testing and Operating Guidelines in your appliance Installation Manual
WARNING: Never use an open flame to check for a leak. Apply commercial leak test solution to all gas joints. Bubbles forming show a leak. Correct all leaks at once.
WARNING: Test all gas piping and connections for leaks after installing or servicing. Correct leaks at once.
WARNING: This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer's instructions and all applicable codes and requirements of the authority having jurisdiction. If the information in these instructions is not followed exactly, a fire, explosion, or production of carbon monoxide may result causing property damage, personal injury, or loss of life. The qualified service agency is responsible for the proper installation of this kit. The installation is not proper and complete until the operation of the converted appliance is checked as specified in the manufacturer's instructions supplied with the kit.
- 20 - | For more information, visit www.desatech.com |
