INSTALLATION
Continued
Assembling Trim (Trim shipped with mantel)
1.Remove packaging from three remaining pieces of trim.
2.Locate two adjusting plates with set screws, and two shims in the hardware packet.
3.Align shim under adjusting plate as shown in Figure 13.
4.Slide one end of adjusting plate/shim in slot on mitered edge of top trim (see Figure 13).
5.Slide other end of adjusting plate/shim in slot on mitered edge of side trim (see Figure 13).
6.While firmly holding edges of trim together, tighten both set screws on the adjusting plate with slotted screwdriver.
7.Repeat steps 1 through 6 for other corner.
8.Set assembly aside for later installation.
Top Trim
Set | Adjusting Plate |
| |
Screws | |
| Slot |
Mitered Edge
Shim
Side Trim 
Figure 13 - Assembling Trim
INSTALLING OPTIONAL BLOWER ACCESSORY GA3450T
Removing Upper Louver
To install the blower accessory, you must first re- move the upper louver.
1.Lift screen off fireplace and remove log set if installed.
2.Remove 4 screws from upper louver (see Fig- ure 14). Save these screws.
3.Pull upper louver straight out from the cabi- net. Be careful not to scratch the paint. Set louver and screws aside.
4.Open lower louver door by swinging door down (see Figure 15, page 15).
Blower
Bracket
Mounting
Holes
Upper Louver
Figure 14 - Removing Upper Louver
Installing Blower Accessory
Note: If you are using a mantel with your fireplace, use the following instructions. If your fireplace is
CAUTION: Label all wires prior to disconnection when ser- vicing controls. Wiring errors can cause improper and dan- gerous operation.
CAUTION: Verify proper op- eration after servicing.
1.Locate fan switch cover. Remover bottom screw to remove back portion of the cover.
2.Install snap bushings found in hardware kit into both holes in rear of fan switch cover.
3.Make sure the wire harness is firmly con- nected to the terminals on the blower bracket assembly.
4.Note the wire locations on back of AUTO/ OFF/ON switch. The terminals on back of switch are numbered 1, 2, and 3. Carefully remove red wire from terminal 3 and blue wire from terminal 1. Black wire can remain on middle terminal 2 (see Figure 15, page 15).
5.Carefully disconnect green and white wires at their insulated connectors (see Figure 16, page 15).
14 | www.desatech.com |
