Desa VMH10TPC, EFS10TNA, EFS10TPA Optional HAND-HELD Remote Operation, ON/OFF Series Model Ghrcb

OPERATING FIREPLACE

Continued

TO TURN OFF GAS

TO APPLIANCE

Shutting Off Fireplace

1. Turn control knob clockwise Clockwise to the

OFF position.

2.If Using Optional Hand-Held Remote: Set remote switch to the OFF position to pre- vent draining battery.

Shutting Off Burner Only (pilot stays lit) You may shut off the burner and keep the pilot lit by doing one of the following:

1. Turn control knob clockwise Clockwise to the

PILOT position.

2.If Using Optional Hand-Held Remote: Use remote control manual OFF button.

WARNING: Make sure re- mote sensor selector switch is in the OFF position when you are away from home for long periods of time.

MANUAL LIGHTING

PROCEDURE

1.Follow steps 1 through 5 under Lighting Instructions, page 26.

2.Depress control knob and light pilot with match.

3.Keep control knob pressed in for 30 sec- onds after lighting pilot. After 30 seconds, release control knob. Now follow step 8 under Lighting Instructions, page 26.

OPTIONAL HAND-HELD

REMOTE OPERATION

Note: All remote control accessories must be purchased separately (see Accessories, page 40). Follow instructions included with the re- mote control.

NOTICE: You must light the pi- lot before using the hand-held remote control unit. See Light- ing Instructions on page 26.

1.After lighting, let pilot flame burn for about one minute. Turn control knob to ON posi- tion. Slide the remote selector switch to the REMOTE position (see Figure 43). Note: The burner may light if hand-held remote was on when the remote selector switch was last turned off. You can now turn the burner on and off with the hand-held re- mote control unit.

IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.

Selector Switch in

REMOTE

Position (Optional

Hand-Held

Remote Control)

Electronic

Control Knob Ignitor

OFF	N
ON
	O		O
REMOTE	O
	T	FF
	LIP

Figure 43 - Setting the Selector Switch and Control Knob for Hand-Held Remote Operation

ON/OFF SERIES (MODEL GHRCB)

Hold the control button on the hand-held remote until burner turns on. Hold the control button again until burner turns off (see Figure 44).

TO LOCK press both buttons on hand-held re- mote control until light stops flashing. Hand- held remote control is now locked. If the fire is on it will be turned off automatically. In the locked state, the light will not light up when any button is pressed.

TO UNLOCK press both buttons together on hand-held remote control until the light stops flashing. The hand-held remote is now unlocked.

Control Button

Turns Burners

On and Off

Figure 44 - On/Off Hand-Held Remote

Control Unit (GHRCB)

112462-01B www.desatech.com 27