2
INSTALLING BLOWER ACCESSORY IN A 32" FIREBOX
INSTALLING BLOWER ACCESSORY IN A 32" FIREBOX
NOTICE: If a log set is currently installed in the firebox, disconnect log set from gas supply and remove from firebox. Contact a qualified service person to do this.
Note: Appearance of firebox may vary slightly depending on model.
1.Remove the firebox bottom:
a.Remove the 4 screws that secure the bottom of the firebox (see Figure 1).
b.Carefully raise and remove the firebox bottom from the firebox.
WARNING: If there is a duplex electrical outlet installed in the right side of the bottom of the fireplace base area, be sure that the electrical power to the outlet is turned off before proceeding with blower installa- tion. Failure to do this may result in serious injury.
2.Attach the power cord to the blower motor by firmly pushing the two female terminals at the end of the power cord onto the two spade terminals on the blower motor.
3.Attach green ground wire from power cord to blower housing us- ing screw provided (see Figure 2). Tighten screws securely.
4.Place the blower against lower rear wall of firebox wrapper with the exhaust port directed upward. Align the holes in top mounting tabs of blower with holes in wall of wrapper (see Figure 2). Using 2 screws provided, mount blower and tighten screws securely.
5.Be certain that all wire terminals are securely attached to ter- minals on blower motor and that the screw retaining the green ground wire is tight.
6.Locate the plastic hole plug installed in the 3/8" diameter open- ing in the lower right side of the firebox front panel (see Fig- ure 2). Remove the plastic plug and discard.
7.Place speed control against inner wall of front panel, pushing the plastic control shaft forward through the opening (see Figure 3).
8.While supporting speed control, secure control shaft with lock nut by pushing and turning lock nut with pliers clockwise un- til it is tight against front panel. Place control knob provided on shaft (see Figure 3).
9.Plug in blower power cord.
a.If your firebox is installed as a freestanding unit, determine whether the power cord will exit the left side or the right side of the firebox. Install 1 plastic bushing provided into the 1 1/2" hole in the floor support on the exit side. Install the second plastic bushing provided into the 1 1/2" hole in the outer casing through which the power cord will exit (see Figure 4). Route power cord through both plastic bushings and plug the power cord into a
b.If your firebox installation is recessed and/or
CAUTION: Never touch the blower wheel while in operation.
Lower Rear Wall
Exhaust Port | of Firebox Wrapper |
| |
| Top |
| Mounting |
| Tab |
Screw |
|
| Screws |
| Floor |
| Blower Supports |
Plastic
Hole Plug
Figure 2 - Mounting Blower to Firebox
Note: Appearance of fireplace may vary by model.
Speed Control
Control Shaft
Lock
Nut
Plastic Bushing
Figure 1 - Removing Screws from Firebox Bottom
Control
Knob
Figure 3 - Attaching Speed Control
Figure 4 - Installing Plastic Bushing for Power Cord
For morevisit www..com