4.Remove mounting brackets and drill a 1/8 inch diameter hole into fireplace housing at each marked location.
5.Use the sheet metal screws provided to fasten brackets to fireplace housing (see Figure 12, page 3).
6.Slide hood over mounting brackets (see Figure 12, page 3).
Installing Into Manufactured Fireplace Opening
1.Discard the mounting brackets.
2.Place the hood inside the fireplace opening as shown in Figure 13.
3.Hold the hood in place and drill four holes through hood and into channel on the fireplace opening (see Figures 14). Make sure holes are evenly spaced and cover most of the hoodʼs length.
4.Use the sheet metal screws provided to fasten the hood to the fireplace opening.
Manufactured
Fireplace
Fireplace
Opening
Figure 13 - Installing Hood Into Opening
of Manufactured Fireplace
Manufactured Fireplace
Approximate Screw
Locations
Fireplace
Opening
Manufactured
Fireplace
Fireplace
Hood
Fireplace
Opening Fireplace
Cross
Section
Figure 14 - Screw Placement
OPERATING FIREPLACE WITH FIREPLACE HOOD
WARNING: Fireplace hood becomes very hot during fire- place operation. Do not touch fireplace hood. Severe burns could occur.
IMPORTANT: Remove all tape used when install- ing fireplace hood before operating fireplace.
If you have any questions, contact DESA at 1-866-672-6040.
2701 Industrial Drive P.O. Box 90004
Bowling Green, KY