Sanding Belt, Backstop | Woodstock W1730 manual

W1730 Oscillating Edge Sander

Sanding Belt

To install the belt, do these steps:

1.Open the belt access door by removing the star knobs and opening all latches.

2.Lift the belt tensioning lever as shown in Figure 11.

3.Determine the belt direction from the arrow on the dust port and the access door.

4.Match the arrows on the sander to the arrows inside the sanding belt, and place and center the belt on the sanding drums as shown in Figure 12.

5.Tension the sanding belt by pushing the belt tensioning lever down.

6.Close the belt access door, insert the star knobs, and latch the levers.

7.Adjust the belt tracking as described on Page 17.

Backstop

To mount the back stop, do these steps:

1.Place a 5/16" flat washer on each 5/16-18 x 1 hex bolt and thread them approximately one turn into the holes in the platen shown in Figure 13.

2.Slide the back stop onto the hex bolts and tighten, allowing 1/8" clearance between the belt and the edge of the back stop.

Figure 11. Released position of the belt

tensioning lever.

Belt Direction

Arrows

Figure 12. Placing the sanding belt onto

the sanding drums.

SETUP

Figure 13. Backstop bolts threaded into

platen.

-13-

Image 15

Woodstock W1730 manual Sanding Belt, Backstop, To install the belt, do these steps, To mount the back stop, do these steps

Contents

Oscillating Edge Sander Page Table of Contents Introduction Woodstock Technical SupportAbout Your New W1730 Oscillating Edge Sander Introduction Controls and Features Standard Machinery Safety Instructions Safety Safety Additional Safety for Oscillating Edge Sanders Do not sand wood with fingers close To spindle Avoiding Potential Injuries Nema ElectricalCircuit Requirements Circuit Type Extension Cords Grounding Requirements Description SET UPItems Needed for Set Up Unpacking Inventory Box Contents Figure Machine Placement Cleaning Machine To mount the back stop, do these steps To install the belt, do these stepsSanding Belt Backstop Dust Port Dust Port DoorDust Port Cover Sanding Spindle To install the sanding spindle, do these steps To check and refill the gear box, do these steps Dust CollectionGear Box Test Run If the belt is not tracking correctly, repeat Steps To adjust the sanding belt tracking, do these stepsBelt Tracking Unplug the sander Emergency Stop Button OperationsGeneral Belt Grits To vertically adjust the table, do these steps Platen Angle AdjustmentTable Adjustment To adjust the platen angle, do these steps Spindle Table Height To adjust the miter gauge, do these stepsMiter Gauge Fence To perform an edge or end sanding operation, do these steps Spindle SandingEnd & Edge Sanding To perform spindle sanding operations, do these steps Maintenance CleaningTable & Base To grease the rack and pinion gear, do these steps Lubrication Eccentric Spindle Connector Every 2,000 hours Maintenance ScheduleMaintenance Notes Every 6-8 Hours of Running Time To calibrate the angle gauge, do these steps Calibrating Angle Gauge To remove the drive roller, do these steps Removing Drive Roller W1730 Wiring Diagram Symptom Possible Cause Troubleshooting During operation Adjustment 195 194 151 188 164 193 190 150 187 163 183 186 Breakdown Description Parts Breakdown Gear BOX Cover Warranty Regristration Woodstock international inc. p.o. box Bellingham, wa Warranty High Quality Machines and Tools