-19-
OPERATIONS
W1730 Oscillating Edge Sander
The sanding angle of the oscillating edge sander is
variable between 0 and 90 degrees.
To adjust the platen angle, do these steps:
1. Loosen the angle adjustment lock handle and tilt
the sander until the pointer is aligned with the
desired angle as shown in Figure 24.
2. Tighten the angle adjustment lock handle.
N o t e : See Page 26 to calibrate the angle scale.
Platen Angle Adjustment
Figure 24. Platen angle scale.
The table on the oscillating edge sander moves both
vertically and horizontally to accommodate various
workpieces shapes and thicknesses. Adjust the table
height periodically to reduce spot wear of your sanding
belt.
To vertically adjust the table, do these steps:
1. Loosen the lock handles (Figure 25) that secure the
table height position.
2. Turn the table height adjustment wheel, shown
in Figure 25, clockwise to raise the table or
counterclockwise to lower the table.
3. When the desired position is achieved, tighten the
lock handles to secure the table height.
To horizontally adjust the table, do these steps:
1. Move the table lock levers to the loose position as
illustrated by the labels on the machine.
2. Push or pull the table until there is a gap of no more
than 1/16" from the sanding belt (Figure 26).
3. Move the table lock levers to the locked position to
secure the table position.
Table Adjustment
Figure 25. Vertical table adjustment.
Figure 26. Horizontal table adjustment.
Angle Adjustment
Lock Handle
Adjustment Wheel
Lock Handle