Avoiding Potential Injuries | Woodstock W1730 guide

W1730 Oscillating Edge Sander

Avoiding Potential Injuries

SAFETY

Figure 2. DO NOT leave a gap between wood and back stop, and keep hands away from belt.

Figure 5. ALWAYS use the back stop, and keep

fingers away from the belt.

Figure 3. DO NOT sand wood with fingers close

to spindle.

Figure 6. ALWAYS keep your fingers away from

the spindle.

Figure 4. DO NOT sand wood with sharp corners at the leading-edge of the sanding operation.

The belt can grab and throw the wood.

-7-

Figure 7. ALWAYS sand wood with sharp corners at the trailing-edge of the sanding operation.

Image 9

Woodstock W1730 manual Avoiding Potential Injuries, Do not sand wood with fingers close To spindle

Contents

Oscillating Edge Sander Page Table of Contents Introduction Woodstock Technical SupportAbout Your New W1730 Oscillating Edge Sander Introduction Controls and Features Standard Machinery Safety Instructions Safety Safety Additional Safety for Oscillating Edge Sanders Do not sand wood with fingers close To spindle Avoiding Potential Injuries Circuit Requirements ElectricalCircuit Type Nema Extension Cords Grounding Requirements Items Needed for Set Up SET UPUnpacking Description Inventory Box Contents Figure Machine Placement Cleaning Machine Sanding Belt To install the belt, do these stepsBackstop To mount the back stop, do these steps Dust Port Dust Port DoorDust Port Cover Sanding Spindle To install the sanding spindle, do these steps Gear Box Dust CollectionTest Run To check and refill the gear box, do these steps Belt Tracking To adjust the sanding belt tracking, do these stepsUnplug the sander If the belt is not tracking correctly, repeat Steps General OperationsBelt Grits Emergency Stop Button Table Adjustment Platen Angle AdjustmentTo adjust the platen angle, do these steps To vertically adjust the table, do these steps Miter Gauge To adjust the miter gauge, do these stepsFence Spindle Table Height End & Edge Sanding Spindle SandingTo perform spindle sanding operations, do these steps To perform an edge or end sanding operation, do these steps Maintenance CleaningTable & Base To grease the rack and pinion gear, do these steps Lubrication Eccentric Spindle Connector Maintenance Notes Maintenance ScheduleEvery 6-8 Hours of Running Time Every 2,000 hours To calibrate the angle gauge, do these steps Calibrating Angle Gauge To remove the drive roller, do these steps Removing Drive Roller W1730 Wiring Diagram Symptom Possible Cause Troubleshooting During operation Adjustment 195 194 151 188 164 193 190 150 187 163 183 186 Breakdown Description Parts Breakdown Gear BOX Cover Warranty Regristration Woodstock international inc. p.o. box Bellingham, wa Warranty High Quality Machines and Tools