W1730 Oscillating Edge Sander

Spindle Connector

MAINTENANCE

The spindle connector connects the shafts from the motor to the gear box and is secured by two set screws that need to be tightened every time the gear box oil is filled (every 500 hours).

To secure the spindle connector set screws, do these steps:

1.Refer to Lubrication Steps 1-3 on Page 23 to remove the gear box cover

2.Tighten the set screws shown in Figure 35.

3.Reinstall the gear box cover.

Eccentric

The eccentric on the Model W1730 is connected to the shaft by a set screw. This set screw needs to be tightened every time the gear box oil is filled (every 500 hours).

To secure the eccentric set screw, do these steps:

1.Refer to Lubrication, Steps 1-3 on Page 23 to remove the gear box cover.

2.Tighten the set screw on the eccentric, shown in

Figure 36.

3.Reinstall the gear box cover.

Figure 35. Spindle connector set screws.

Figure 36. Eccentric set screw.

-24-

Page 26
Image 26
Woodstock W1730 manual Spindle Connector, Eccentric