W1730 Oscillating Edge Sander

Removing Drive Roller

The Model W1730 comes equipped with a puller to remove the drive roller should it ever become necessary to do so.

To remove the drive roller, do these steps:

1.Remove the hex nut and lock washer securing the driver roller to the shaft.

2.Thread the two 1/4-20 x 1-3/4 cap screws on the puller four turns into the threaded holes in the drive roller.

3.Thread and tighten the 5/16-18 x 1-1/4 cap screw into the puller, shown in Figure 39, until the drive roller is pulled.

4.To re-install, place the drive roller on the shaft, and thread the lock washer and hex nut onto the shaft and tighten securely. Note: Do not hammer the drive roller onto the shaft or you will cause damage to the shaft.

Figure 39. Using the drive roller puller.

SERVICE

-27-

Page 29
Image 29
Woodstock W1730 manual Removing Drive Roller, To remove the drive roller, do these steps