During operation Adjustment | Woodstock W1730 specification

				W1730 Oscillating Edge Sander




SYMPTOM		POSSIBLE CAUSE		corrective action
Glazed Sanding Belt	1.	Sanding wet stock.	1.	Dry stock properly before sanding.
	2.	Sanding stock with high residue.	2.	Use different stock. Or, accept the characteristics
				of the stock and plan on cleaning/replacing belts
				frequently.

Burn marks on workpiece	1.	Using too fine of sanding belt grit.	1.	Use a coarser grit sanding belt.
	2.	Using too much pressure against	2.	Reduce pressure on workpiece while sanding.
		belt.
	3.	Work held still for too long.	3.	Do not keep workpiece in one place for too long
				and allow to cool.
Sanding belt clogs quickly	1.	Using too much pressure against	1.	Reduce pressure one workpiece while sanding.
or burns.		belt.
	2.	Sanding softwood.	2.	Use different stock. Or, accept the characteristics
				of the stock and plan on cleaning/replacing belts
				frequently.

Workpiece frequently get	1.	Not supporting the workpiece	1.	Use back stop to support workpiece.
pulled out of your hand.		against the stop.
	2.	Starting the workpiece on a	2.	Start workpiece on a trailing corner.
		leading corner.

Sanding belt comes off	1.	Tracking/Oscillation out of	1.	Set belt tracking as described in Setup on Page 17.
during operation.		adjustment.

SERVICE

-30-

Image 32

Woodstock W1730 manual During operation Adjustment

Contents

Oscillating Edge Sander Page Table of Contents About Your New W1730 Oscillating Edge Sander IntroductionWoodstock Technical Support Controls and Features Introduction Safety Standard Machinery Safety Instructions Safety Additional Safety for Oscillating Edge Sanders Avoiding Potential Injuries Do not sand wood with fingers close To spindle Electrical Circuit RequirementsCircuit Type Nema Grounding Requirements Extension Cords SET UP Items Needed for Set UpUnpacking Description Box Contents Figure Inventory Machine Placement Cleaning Machine To install the belt, do these steps Sanding BeltBackstop To mount the back stop, do these steps Dust Port Cover Dust PortDust Port Door To install the sanding spindle, do these steps Sanding Spindle Dust Collection Gear BoxTest Run To check and refill the gear box, do these steps To adjust the sanding belt tracking, do these steps Belt TrackingUnplug the sander If the belt is not tracking correctly, repeat Steps Operations GeneralBelt Grits Emergency Stop Button Platen Angle Adjustment Table AdjustmentTo adjust the platen angle, do these steps To vertically adjust the table, do these steps To adjust the miter gauge, do these steps Miter GaugeFence Spindle Table Height Spindle Sanding End & Edge SandingTo perform spindle sanding operations, do these steps To perform an edge or end sanding operation, do these steps Table & Base MaintenanceCleaning Lubrication To grease the rack and pinion gear, do these steps Spindle Connector Eccentric Maintenance Schedule Maintenance NotesEvery 6-8 Hours of Running Time Every 2,000 hours Calibrating Angle Gauge To calibrate the angle gauge, do these steps Removing Drive Roller To remove the drive roller, do these steps W1730 Wiring Diagram Troubleshooting Symptom Possible Cause During operation Adjustment 195 194 151 188 164 193 190 150 187 163 183 186 Breakdown Parts Breakdown Description Gear BOX Cover Warranty Regristration Woodstock international inc. p.o. box Bellingham, wa Warranty High Quality Machines and Tools