INSTALLATION
Continued
13.Place mantel around fireplace. Be careful not to damage wall or mantel.
14.Place brass trim kit on the shoulder screws located on the side and top of the fireplace. Firmly snap the brass trim over the shoulder screws on fireplace (see Figure 13, page 12).
15.Adjust assembly to remove any gaps. Attach remaining two 3" wood screws from hardware pack through openings inside of fireplace sides into the mantel. The openings are located at top behind the area for the louvers (see Figure 13, page 12).
16.Reinstall top louvers.
1 3/4" Screw
Wood Base
Figure 14 - Attaching Wood Base to
Floor
ASSEMBLING BRASS TRIM (Brass trim shipped with mantel)
1.Remove packaging from three remaining pieces of brass trim.
2.Locate two adjusting plates with set screws and two shims in the hardware packet.
3.Align shim under adjusting plate as shown in Figure 15.
4.Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim (see Figure 15).
5.Slide other end of adjusting plate/shim in slot on mitered edge of side brass trim (see Figure 15).
6.While firmly holding edges of brass trim to- gether, tighten both set screws on the adjusting plate with slotted screwdriver.
7.Repeat steps 1 through 6 for other corner.
8.Set brass assembly aside for later installation.
|
| Top Brass | |
|
| Trim |
|
| Set Screws | Slot |
|
Adjusting |
|
| |
Plate |
|
| |
|
|
| Side |
|
| Mitered | Brass |
|
| Edge | Trim |
| Shim |
|
|
| Slot |
|
|
| Figure 15 - Assembling Brass Trim | ||
INSTALLING BLOWER ACCESSORY | |||
GA3450T |
|
| |
Removing Upper Louver Assembly | |||
To install the blower accessory, you must first | |||
remove the upper louver assembly. |
| ||
1. | Lift screen off heater. |
| |
2. | Remove 4 screws from louver assembly (see | ||
| Figure 16). Save these screws. |
| |
3. | Pull louver assembly straight out from the | ||
| cabinet. Be careful not to scratch the paint. | ||
| Set louver assembly and screws aside. | ||
|
| Blower Bracket | |
|
| Mounting Holes | |
|
| Upper |
| Screws | Louver |
| Assembly | |
|
| |
Figure 16 | - Removing Upper Louver | |
Assembly |
|
|
www.desatech.com | 13 |
