WARNING Never install the ﬁreplace, Continued

INSTALLATION

Continued

Note: Your ﬁreplace is designed to be used in zero clearance installations. Wall or framing material can be placed directly against any exterior surface of your ﬁreplace, except where standoff spacers are integrally attached. If standoff spacers are attached to your ﬁreplace, these spacers can be placed directly against wall or framing materials.

Use the dimensions shown for rough openings to create the easiest installation (see Built-In Fire- place Installation, page 10).

CHECK GAS TYPE

Use the correct gas type (natural or propane/LP) for your unit. If your gas supply is not correct, do not install ﬁreplace. Call dealer where you bought ﬁreplace for proper type ﬁreplace.

WARNING: This appliance is equipped for (natural or pro- pane/LP) gas. Field conversion is not permitted.

INSTALLATION ITEMS

Before installing ﬁreplace, make sure you have the items listed below.

•external regulator - propane/LP only (supplied by installer)

•piping (check local codes)

•sealant (resistant to propane/LP gas)

•equipment shutoff valve *

•test gauge connection *

•ground joint union

•sediment trap

•tee joint

•pipe wrench

*A CSA design-certiﬁed equipment shutoff valve with 1/8" NPT tap is an acceptable alternative to test gauge connection. Purchase the optional CSA design-certiﬁed equipment shutoff valve from your dealer. See Accessories, page 30.

Note: If desired, purchase a four-sided brass trim kit for built-in installations. See Accessories, page 30.

LOCATING FIREPLACE

WARNING: Maintain the minimum clearances shown in Figures 7 and 8. If you can, provide greater clearances from ﬂoor, ceiling and joining wall.

You can recess ﬁrebox into the wall. You can also position ﬁreplace in the optional cabinet or corner mantels. IMPORTANT: Only use optional cabinet or corner mantels speciﬁed in this manual. Purchase the optional mantel from your dealer (see Accessories, page 30).