Desa K42EN, K42EP installation manual Removing Glass Door, Cleaning Glass Door

FIREPLACE INSTALLATION

Removing/Replacing Glass Door (Cont.) Installing Optional Brick Liner Models BL42DA(SA), BL42DHA(SA)

21

FIREPLACE INSTALLATION

Continued

Removing Glass Door

If replacement of glass is necessary, the entire assembly, glass and frame, must be replaced. If glass is broken, wear gloves and tape the remaining fragments onto the frame.

1.Remove screen assembly by pushing the rod either left or right and then down and forward to remove screen/rod assembly from the firebox. Set assembly aside.

2.Lift up on latches to unlock. There are two on top of firebox and two below firebox that hold glass door in place (see Figure 37).

3.While holding glass door to prevent it from falling and caus- ing injury, remove the five screws from the hinge located on the left side of door frame assembly (see Figure 37).

4.Remount the new frame at the hinge with five new screws before closing door. This will ensure seating of the gasket.

5.Close glass door frame. Lock latches by placing the bar under the tab on door and pushing down and back on latch (see Figure 37).

6.Replace screen/rod assembly by reversing step 1.

7.Replace louvers by reversing procedure under Removing Lou- ver Panels, page 20.

Latch Unlock Lock

Hinge

Screw

Glass Frame

Assembly

Figure 37 - Removing/Replacing Glass Door

INSTALLING BRICK LINER MODELS BL42DA(SA), BL42DHA(SA)

WARNING: If fireplace has been running, turn off and unplug fireplace. Let cool before installing brick liner.

You may purchase brick liner from your local retailer or see Accessories, page 34.

CAUTION: Always handle brick panels with two hands. Do not force brick panels into place. Exces- sive force will break brick panels.

1.Remove top and bottom louvers to allow access to door latches.

2.Remove screen, unlock door latches and open glass door. See Removing/Replacing Glass Door, steps 1 and 2.

3.If installing brick liner in new fireplace, go to step 4. If install- ing brick liner in an existing fireplace, carefully remove logs, lava rock, and ember material.

4.Remove three screws from deflector shield on the inside top of firebox. Set shield and screws aside.

5.Install rear brick panel first. Rest bottom edge of panel on back edge of grate (see Figure 38).

6.Install left side brick panel by sliding it between the grate and the side of the firebox (see Figure 38).

7.Install the right brick panel using the same method described in step 6 for left brick panel.

8.Replace deflector shield using screws removed in step 4.

9.Install logs, lava rock and glowing embers. See Installing Logs, Lava Rock and Glowing Embers, page 22.

10.Close glass door and lock latches on top and bottom of door and replace screen. See Removing/Replacing Glass Door, steps 5 and 6.

11.Close top and bottom louvers.

Cleaning Glass Door

See Cleaning and Maintenance on page 26.	Left Brick
	Panel
	Rear Brick
	Panel

Figure 38 - Installing Rear, Left and Right Brick Panels

For morevisit www..com

111922-01C