Installing Logs, Installing Screen

OWNER’S MANUAL

INSTALLATION

Continued

INSTALLING LOGS

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION: Do not remove the warning and instruction labels attached to the heater base as- sembly. These markings contain important warranty information.

WARNING: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to High, check to see if flames contact any log. If so, re- position logs according to the log installation instructions in this manual. Flames contacting logs will create soot.

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Place the base of the middle log (#1) in the U-shaped slots of the grate base. The cutout on the right of the middle log should fit over the burner (see Fig- ure 21). Make sure the front of the middle log is resting on the tabs of the grate base and the cutout area is cen- tered over the burner “U” bend.

2.Locate pegs on the bottom of back log (#2). Slide these pegs into the holes in the grate base behind the burner (see Figure 22).

3.Locate the notches in the bottom of the front log (#3). Place the front log on the grate fingers. Make sure the notches of the front log line up with the grate fingers (see Figure 23).

4.Place crossover log (#4) onto the peg (right) on back log (#2) and into the re- cess of the middle log (#1) (see Figure 24).

Middle Log (#1)

"U"-shaped Cutout in Base

Burner

Figure 21 - Installing Middle Log (#1)

Back Log (#2)

Peg

Hole in Base

Peg

Figure 22 - Installing Back Log (#2)

Front Log (#3)

Notches

Grate Fingers

Figure 23 - Installing Front Log (#3)

Crossover Log (#4)

Peg

Recess

Figure 24 - Installing Crossover Log (#4)

INSTALLING SCREEN

WARNING: You must operate this fireplace with the fireplace screen in place. Make sure fire- place screen is in place before running fireplace.

Install fireplace screen by slipping notches of fireplace screen over screws on front of fireplace (see Figure 25).

Notches

Screws for

Mounting Screen

Figure 25 - Installing Fireplace Screen