INSTALLATION
Continued
INSTALLING HEATER TO WALL
Mounting Bracket
Locate mounting bracket that has been taped to back panel of heater for shipping. Remove mount- ing bracket from back panel of heater.
Figure 9 - Mounting Bracket
Methods For Attaching Mounting Bracket To Wall
Only use last hole on each end of mounting bracket to attach bracket to wall. These two holes centers are 13" (33 cm) apart. Attach mounting bracket to wall in one of two ways:
1.Attaching to wall stud
2.Attaching to wall anchor
Attaching to Wall Stud: This method provides the strongest hold. Insert mounting screws through mounting bracket and into wall studs.
Attaching to Wall Anchor: This method allows you to attach mounting bracket to hollow walls (wall areas between studs) or to solid walls (concrete or masonry).
Decide which method better suits your needs. Either method will provide a secure hold for the mounting bracket.
Marking Screw Locations
1.Tape mounting bracket to wall where heater will be located. Make sure mounting bracket is level.
WARNING: Maintain mini- mumclearancesshowninFigure
10.If you can, provide greater clearances from floor and join- ing wall.
2.Mark screw locations on wall (see Figure 10).
Note: Only mark last hole on each end of mounting bracket. Insert mounting screws through these holes only.
3.Remove tape and mounting bracket from wall.
Attaching Mounting Bracket To Wall Note: Wall anchors, mounting screws and spacers are in hardware package. The hardware package is provided with heater.
| 12" | 13" (33 cm) |
| |
| (30.4 |
|
| |
| cm) |
|
| |
AdjoiningWall | Min. |
|
| |
Only Insert Mounting | 11" | |||
Screws Through Last | ||||
(27.9 cm) | ||||
|
| Hole On Each End | Min. | |
|
|
| ||
Floor
Figure 10 - Mounting Bracket Clearances
Attaching To Wall Stud Method
For attaching mounting bracket to wall studs
1.Drill holes at marked locations using 9/64" drill bit.
2.Place mounting bracket onto wall. Line up last hole on each end of bracket with holes drilled in wall.
3.Insert mounting screws through bracket and into wall studs.
4.Tighten screws until mounting bracket is firmly fastened to wall studs.
Attaching To Wall Anchor Method
For attaching mounting bracket to hollow walls (wall areas between studs) or solid walls (concrete or masonry)
1.Drill holes at marked locations using 5/16" drill bit. For solid walls (concrete or masonry), drill at least 1" deep.
2.Fold wall anchor as shown in Figure 11.
3.Insert wall anchor (wings first) into hole. Tap anchor flush to wall.
4.For thin walls [1/2" (1.3 cm) or less], insert red key into wall anchor. Push red key to “pop” open anchor wings. IMPORTANT: Do not hammer key! For thick walls [over 1/2" (1.3 cm) thick] or solid walls, do not pop open wings.
5.Place mounting bracket onto wall. Line up last hole on each end of bracket with wall anchors.
Figure 11 - Folding Anchor
Figure 12 - Popping Open Anchor Wings
For Thin Walls
10 | www.desatech.com |
