INSTALLATION
Continued
INSTALLATION ITEMS
Before installing heater, make sure you have the items listed below.
•for propane/LP gas, external regulator (supplied by installer)
•piping (check local codes)
•sealant (resistant to propane/LP gas)
•equipment shutoff valve *
•ground joint union
•sediment trap
•tee joint
•pipe wrench
•for natural gas, test gauge connection*
*A CSA
REMOVING FRONT PANEL OF HEATER
1.Remove and discard shipping screw from back panel of heater (see Figure 4).
2.Remove the four screws, two on each side of front panel. Set aside.
3.Pull front panel forward from the bottom, then lift panel up to remove. If ignitor is installed, pull front panel forward only 2" to 3" (5 to 7.6 cm) away from back panel. Reach into lower right side of heater and disconnect ignitor wire. Set front panel aside.
4.Remove any remaining packaging materials.
Shipping
Screw
Location
Front Panel |
| Ignitor |
|
| |
| Screw | Wire |
|
| |
Figure 4 - Removing Front Panel Of Heater | ||
Installing Glass Panel
Items needed from hardware packet:
1 - Bushing
4 - Black spacers
4 - Retaining clips
4 - 1.5" long screws
4 - Screw covers
1.Locate hardware packet and dark acrylic glass.
2.Peel protective coating from both sides of glass.
3.Snap bushing into center front hole of front panel (see Figure 5).
4.Turn front panel face down. Gently press onto a hard surface to snap bushing into hole. Turn panel back over, face up.
5.Place spacers over 4 holes on front panel as shown in Figure 5.
6.Position glass on top of spacers, aligning holes. Note: If glass gets scratched or marred from normal use, it may be reversed on heater.
7.Place 4 retaining clips on glass over holes.
8.Install screws in each hole, but do not tighten at this time.
9.Square glass up with top front surface of front panel. Tighten screws.
10.Snap screw covers over retaining clips.
Screw Cover | Bushing |
| |
Retainer Clip |
|
Glass Panel | Spacer | Front |
| ||
| Screw | Panel |
|
| |
Figure 5 - Installing Glass Panel | ||
INSTALLING IGNITOR |
| |
1.Locate ignitor in hardware bag. Determine if your heater is equipped with piezo ignitor or an electronic ignitor (see Figures 6 and 7, page 9.
2.For Piezo Ignitor, snap ignitor into hole located on right side of heater as shown in Figure 6, page 9.
3.For Electronic Ignitor, install ignitor through hole located on right side of heater as shown in Figure 7, page 9.
8 | www.desatech.com |
