Desa LSL3124N installation manual Specifications, Logs, Cleaning And Maintenance, Continued

CLEANING AND MAINTENANCE

Cleaning Burner Injector Holder and Pilot Air Inlet Hole (Cont.) Logs

SPECIFICATIONS

19

CLEANING AND

MAINTENANCE

Continued

Clean the pilot assembly also. A yellow tip on the pilot flame indicates dust and dirt in the pilot assembly. There is a small pilot air inlet hole about two inches from where the pilot flame comes out of the pilot assembly (see Figure 30). With the unit off, lightly blow air through the air inlet hole. You may blow through a drinking straw if compressed air is not available.

SPECIFICATIONS

	Echo Valley Oak Log
	Variable Manually-Controlled
Btu (Variable)	16,000/31,500
Type Gas	Propane/LP - Natural
Ignition	Piezo
Manifold Pressure	8.0" W.C. - 3.5" W.C.
Inlet Gas Pressure (in. of water)
Maximum	14" - 10.5"

Burner Tube

Primary Air Inlet Holes (Shape of Holes May Vary by Model)

Injector Holder (May Be Brass or Aluminum Depending on Model)

Minimum*	11" - 5"
Shipping Weight	38 lbs.
* For purpose of input adjustment

	Meadowbrook Oak Log
	Thermostatically-Controlled
Btu (Variable)	26,000/39,000
Type Gas	Propane/LP - Natural
Ignition	Piezo
Manifold Pressure	8.0" W.C. - 3.5" W.C.

Figure 29 - Injector Holder On Outlet Burner Tube

Ports/Slots

Burner Tube

Pilot Assembly

Pilot Air

Inlet Hole

Figure 30 - Pilot Inlet Air Hole

LOGS

•If you remove logs for cleaning, refer to Installing Logs, pages 13 and 14, to properly replace logs.

•Replace log(s) if broken or chipped (dime-sized or larger).

Inlet Gas Pressure (in. of water)
Maximum	14" - 10.5"
Minimum*	11" - 5"
Shipping Weight	28 lbs.

* For purpose of input adjustment

For morevisit www..com

111347-01B