Desa MSVFBP Stove Cavity Assembly, Lift off corrugated box enclosing stove body crating

SUN VALLEY STOVE COMPANY

VENT-FREE PROPANE/LP GAS STOVE HEATER

INSTALLATION

Continued

STOVE CAVITY ASSEMBLY

1.Lift off corrugated box enclosing stove body crating.

2.Remove all screws fastening the wood frame enclosure. Spread wood frame open and lift away from plastic-bagged stove body. The bottom pieces of pallet wood will remain bolted to the stove body.

3.Remove plastic bag from stove body.

4.Remove back panel from stove (see Figure 5). Use an adjustable wrench or a 10 mm socket. Remove six (6) bolts and washers. Keep bolts and washers to reattach back panel later.

5.Remove all contents from inside stove cavity. Contents include:

(1) - Stove bottom

(4)- Legs (include leg leveler bolts)

(1)- Bottom door

(1)- Top grate

(1)- Hardware kit bag with fasteners

6.Carefully lay stove body on back to at- tach bottom components to stove body (see Figure 6). Rest stove on drop cloth or blanket to avoid scratching stove edges.

7.Remove remaining pallet wood attached to bottom of stove body (see Figure 7). Use an adjustable wrench to remove bolts.

CAUTION: Cast iron is brittle. Do not overtighten bolts or screws during assemlby.

8.Fasten each leg to stove with four (4) M8 x 1.25 - 20mm bolts. Use a flat washer and lock washer with each bolt. Tighten bolts into threaded holes on stove body (see Figure 8, this page, and Figure 9 on page 9). Use an adjustable wrench or a 12mm socket.

9.Fasten stove bottom to stove with four

(4) M6 x 1 - 25mm bolts. Use a flat washer and lock washer with each bolt. Tighten bolts into threaded holes on stove body (see Figure 8, this page and Figure 10 on page 9). Use an adjust- able wrench or a 10mm socket.

Bolt	Product	Back
	Identification	Stove
	Label	Panel

Figure 5 - Removing Back Panel
Top of Stove Unit
	Front of
	Stove Unit	Top of
Front of		Stove
Stove Unit		Unit
	Pallet Wood
Drop Cloth/	Bolted to
Blanket	Stove Body
	Bottom

Figure 6 - Laying Down Stove On Side

Front

Bolt	Pallet
	Wood

Bottom Of

Stove Unit

Pallet

Wood

Figure 7 - Removing Pallet Wood From The Bottom of The Stove

Door Hinge Step		Door Catch Bolt
Bolt Hole	Front	With Adjustable
		Hex Nuts Hole
Leg		Leg
Hole		Hole
	Stove	Bottom Of
		Stove Unit
	Bottom
	Hole
Leg		Leg
Hole		Hole

Figure 8 - Locating Threaded Holes for Stove Bottom, Legs, and Door Attachment (Appearance May Vary Depending on Model)

For more information, visit www.desatech.com 8 105986