
ä
PORTABLE GASOLINE GENERATORS
MAINTENANCE AND REPAIRS
WARNING: Only a qualified electrical service person should service and repair the alternator on this generator. Use only fac- tory approved replacement parts.
CAUTION: The engine speed is preset. The throttle is locked in preset position. Do not adjust throttle. Preset position lets en- gine run at 3600 RPM under load. The engine must maintain 3600 RPM for generator to create cor- rect voltage. Running engine at lower speeds will damage gen- erator and powered items.
CAUTION: Shut off generator before performing maintenance.
IMPORTANT: Keep generator level when servicing. Never turn generator upside down or stand it on end to service.
Note: We supply the engine Owner’s Manual with generator. Refer to that manual for questions concerning engine mainte- nance and repairs.
STORAGE
WARNING: Remove all fuel from fuel tank before storing gen- erator. Store fuel in approved con- tainer. Store fuel in a
WARNING: The muffler be- comes very hot during operation. The muffler remains hot for a while after shutdown. Let engine cool before storing.
IMPORTANT: Keep generator level while in storage. Never store generator upside down or standing on end.
Note: We supply the engine Owner’s Manual with generator. Refer to that manual for questions concerning engine storage.
Use a fuel additive, such as
Cover and store generator in a clean, dry place. Do not expose generator to extreme high or low temperatures during storage.
TROUBLESHOOTING
Note: For additional help, vist DESA International’s Technical Service web site at www.desatech.com.
Note: See engine Owner’s Manual for en- gine troubleshooting.
WARNING: Only a qualified electrical service person should service and repair generator. Use only factory approved replacement parts.
OBSERVED PROBLEM | POSSIBLE CAUSE | REMEDY |
No voltage when starting generator with no electrical load
1. | Defective capacitor | 1. | Replace capacitor |
2. | Winding short circuit or loose connections | 2. | Check resistance of coils (see Electri- |
|
|
| cal Component Specifications, page 15) |
3. | Defective rotor diode | 3. | Replace both diodes on rotor |
4. | Loss of residual magnetism | 4. | Apply |
|
|
| minals for |
Voltage is less than normal voltage with no electrical load
1. | Engine speed too low | 1. | Set engine speed to 3720 RPM (62 Hz) |
|
|
| with no load |
2. | Defective rotor diode | 2. | Replace both diodes on rotor |
3. | Partial short circuit in winding | 3. | Check resistance of coils (see Electri- |
|
|
| cal Component Specifications, page 15) |
4. | Defective capacitor | 4. | Replace capacitor |
Voltmeter reading more than 10% high with 1. Engine speed too high | 1. Set engine speed to 3720 RPM (62 Hz) |
no electrical load | with no load |
|
|
Voltmeter reading correct with no electrical load, but more than 10% low when electri- cal load is added
1. | Defective rotor diode | 1. | Replace both diodes on rotor |
2. | Electrical load too high | 2. | Do not overload generator |
3. | Engine not running properly | 3. | Contact an authorized engine service |
| www.desatech.com |
| center |
|
|
|
14 | 106746 |