Location and Space Requirements (Cont.)
CAST IRON STOVE AND
Stove Body Assembly
5
PRE-INSTALLATION PREPARATION
Continued
4" 
4"
Figure 4 - Clearance for Corner Installation
26 1/4"
Front
19 1/2"
7.Carefully lay stove body on back to attach bottom components to stove body (see Figure 7). Rest stove on drop cloth or blanket to avoid scratching stove edges.
8.Remove remaining pallet wood attached to bottom of stove body (see Figure 8). Use an adjustable wrench to remove bolts.
9.Fasten each leg to stove with four (4) M8 x 1.25 - 20mm bolts. Use a flat washer and lock washer with each bolt. Tighten bolts into threaded holes on stove body (see Figure 9 and Figure 10 on page 6). Use an adjustable wrench or a 12mm socket.
Bolt
Back Stove
Panel
Figure 6 - Removing Back Panel (Amity™ Only)
Figure 5 - Stove With Burner System Bottom Dimensions
CAST IRON STOVE AND B-VENT BURNER SYSTEM ASSEMBLY
STOVE BODY ASSEMBLY
1. | Lift off corrugated box enclosing stove body crating. |
2. | Remove all screws fastening the wood frame enclosure. Spread wood |
Top of Stove Unit
Front of
Stove
Unit
Drop
Cloth/
Blanket
Front of | Top of | |
Stove | ||
Stove Unit | ||
Unit | ||
|
Pallet
Wood
Bolted to
Bottom of
Stove
Body
frame open and lift away from |
tom pieces of pallet wood will remain bolted to the stove body. |
Figure 7 - Laying Down Stove On Side
Front
3.Remove plastic bag from stove body.
4.Locate the product identification label on the carton and record the model number and 7 digit serial number in the space provided in the back of this owner’s manual. Retain this operation and installa- tion manual for future reference and warranty.
Bolt | Pallet |
| Wood |
Pallet Wood | Bottom Of | |
Stove Unit | ||
|
5.Amity Only: Remove back panel from stove and discard (see Figure 6). Use an adjustable wrench or a 10 mm socket. Re- move six (6) bolts and washers. Keep bolts and washers to reattach rear cover.
6.Remove all contents from inside stove cavity. Contents include:
(1)- Stove bottom [Amity Only] (Discard - Not used with this application)
(4)- Legs with leg leveler bolts
(1)- Bottom door
(3)- Top grates
(1)- Hardware kit bag with fasteners
Figure 8 - Removing Pallet Wood From The Bottom of The Stove
Door Hinge | Front | Door Catch Bolt |
Step Bolt Hole |
| With Adjustable |
|
| |
|
| Hex Nuts Hole |
Bottom Of
Stove Unit
Leg Hole
Figure 9 - Locating Threaded Holes for Legs and Door Attachment
For more
visit www.
.com
