Desa SBVBP Removing Front Surround Panel, Removing Screen Optional, Amity Models

6

CAST IRON STOVE AND B-VENT BURNER SYSTEM ASSEMBLY

Stove Body Assembly (Cont.)

CAST IRON STOVE AND B-VENT BURNER SYSTEM ASSEMBLY

Continued

10.Attach stove door by inserting step bolt through door hinge pivot hole and into threaded hole in stove body (see Figure 11 and Figure 9 on page 5). Use an adjustable wrench or a 12mm socket to fasten step bolt. Tighten step bolt until snug. Make sure door moves freely.

11.Install door catch bolt (M8 x 1.25-55mm with two M8 hex nuts) into threaded hole on stove body (see Figure 9, page 5). Use an adjustable wrench or a 12mm socket. The catch bolt has two hex nuts attached to it (see Figure 12). The top nut is a bolt stop and the bottom nut is for door leveling adjustment.

12.Check general catch bolt alignment with door claw. Make fi- nal adjustment and door leveling after stove is in normal stand- ing position.

13.Carefully lift stove back up on its four attached legs.

Removing Front Surround Panel

Remove 2 bolts from bottom of stove and set aside. Remove bolt from the top of the stove to remove the front panel assembly (see Figure 13).

Removing Screen (Optional)

Amity Models

1.Lay the front panel assembly face down on a protected sur- face. Remove the two screws that hold the front plate onto the front surround plate (see Figure 14). Save these screws.

2.Remove the screws and washers that hold the screen onto the front surround plate. Discard these screws, washers, and screen (see Figure 14).

3.Replace the two screws from step 1 to reassemble the front plate and the front surround plate. Set this assembly aside un- til burner system has been installed, logs have been placed inside of burner system, and glass door to burner system insert has been replaced.

Oxford or Victor Hearth Models

1.Lay the front panel assembly face down on a protected sur- face. Remove the screws and washers that hold the screen onto the front surround plate. Discard these screws, washers, and screen (see Figure 14).

2.Set this assembly aside until burner system has been installed, logs have been placed inside of burner system, and glass door to burner system insert has been replaced.

Stove Body Bolt

Front

Assembly

Washers	Bottom Of
Bolt	Stove Unit
	Leg		Figure 13 - Removing Front Assembly (Oxford™ Model Shown)
Figure 10 - Attaching Stove Legs (Oxford™ Model Shown)			Front	Screws
					Screw with
			Surround		Washer
			Plate
Stove Door
Threaded	Door	Bolt Stop	Screw with
Hole
			Washer		Screen
Door Hinge
			Screen
Step	Door Claw	Adjusting			Front Surround
					Plate and
Bolt		Nut
			Front Plate		Doors
	Catch Bolt		Amity™ Model		Oxford™ or Victor Hearth™
					Models
Bolt Shoulder
	Figure 12 - Catch Bolt and		Figure 14 - Removing Screen from Front Assembly
Figure 11 - Attaching Stove Door
	Door Claw Orientation

For..com

112127-01B