Desa SH-5597 Test And Adjustment, Specifications, Bottom of Sensor, Maximum Range, MotionMotion

Clamp Screw

Ball

Joint

Aim Sensor

Down for Short

Coverage

Aim Sensor

Higher for Long

Coverage

TEST AND ADJUSTMENT

❒Turn on the circuit breaker and light switch.

NOTE: Sensor has a 1 1/2 minute warm up period before it will detect motion. When first turned on, wait 1 1/2 minutes.

❒Turn the RANGE control to the mid position, DUALBRITE® to OFF and the ON-TIME control to the TEST position.

MAX		ON-TIME	DUAL BRITE™
	O
	B
	O
	S
	T
MIN	TEST 1 5 20		OFF 3 6 DUSK TO
RANGE
		MINUTES	HOUR DAWN

Bottom of Sensor

Avoid aiming the control at:

•Objects that change temperature rapidly, such as heating vents and air conditioners. These heat sources could cause false triggering.

•Areas where pets or traffic may trigger the control.

•Nearby large, light-colored objects reflecting light may trigger the shut-off feature. Do not point other lights at the sensor.

240°

❒ Loosen the clamp screw in the sensor ball joint and gently rotate the sensor.

❒ Walk through the coverage area noting where you are when the lights turn on (also, the LED will flash several times whenmotionisdetected).Move the sensor head up, down, or sideways to change the cover- age area. Keep the sensor at least 2" (2.5 cm) away from the lamps.

❒Adjust the RANGE as needed. RANGE set too high may

increase false triggering.

❒ Secure the sensor head by tightening the clamp screw. Do not overtighten the screw.

❒Set the amount of TIME you want the lights to stay on after motion is detected (1, 5, or 20 minutes).

❒Set the DUALBRITE® switch to the amount of time after dusk you want the lights on at low level (Off, 3, 6 Hrs., Dusk-to-Dawn).

NOTE: DUALZONE™ is a new zone of detection which was added as an option to select Heath®/Zenith motion sensing products. This feature adds a zone of detec- tion under the motion sensor. DUALZONE™ requires no additional adjustment and operates in conjuction with the forward-looking sensor.

15 ft.
(4.6 m)	DUALZONE™
DUALZONE™	70 ft. 100 ft.
	(21 m) (30.5 m)
	Boosted	Maximum
Maximum Range		Coverage Angle

The detector is less sensitive to motion directly towards it.

MotionMotion

DUALZONE™	Sensor	DUALZONE™
Least Sensitive		Most Sensitive

SPECIFICATIONS

Horizontal Range. . . . Up to 70 ft. (21 m); 100 ft. (30.5 m) with Range Boost. [varies with surrounding temperature]

Vertical Range . . . . . . Up to 15 ft. (4.6 m)

Sensing Angle . . . . . . Up to 240° horizontal. Up to 80°

Vertical

Electrical Load. . . . . . Up to 200 Watt Maximum In- candescent [Up to 100 Watt Maximum each lamp holder.]

Power Requirements . 120 VAC, 60 Hz

Operating Modes . . . . TEST, AUTO, and MANUAL

MODE

Time Delay . . . . . . . . 1, 5, 20 minutes

DUALBRITE® Timer . . . . 3, 6 hours, Dusk-to-Dawn Replacement lamp. . . T4 100W, G8 halogen bi-pin 120

VAC

DESA Specialty Products™ reserves the right to dis- continue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.

598-1162-01 3