OPERATING HEATER
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING
WARNING ICON | G 001 |
If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician or gas supplier. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING INSTRUCTIONS
NOTICE
During initial operation of new heater, burning logs will give off a paper- burning smell. Open damper or window to vent smell. This will only last a few hours.
1.STOP! Read the safety information above.
2.Make sure manual shutoff valve is fully open.
3.Press in and turn control knob clockwise 
to the OFF position.
Ignitor Button
Control Knob
18
Figure 21 - Control Knob and Ignitor Button Location
104024
