FIREPLACE INSTALLATION
Installing Optional Brick Liner Models BL32D, BL36D(S), BL36DH(S) Installing Logs, Lava Rock and Glowing Embers
23
FIREPLACE INSTALLATION
Continued
4.Remove three screws from deflector shield on the inside top of firebox. Set shield and screws aside.
5.Install rear brick panel first. Rest bottom edge of panel on back edge of grate (see Figure 43).
6.Install top brick panel (T36 Series only) by resting on the top of the rear panel. Hold the top brick panel in place and install left side brick panel by sliding it between the grate and the side of the firebox, securing top panel (see Figure 44).
7.Install the right brick panel using the same method described
8.Replace deflector shield using screws removed in step 4.
9.Follow instructions on page 24 to install logs, lava rock, and ember material.
10.Close glass door, lock latches on top and bottom of door and replace screen (see steps 5 and 6 of Removing/Replacing Glass Door, page 22).
11.Close top and bottom louvers.
INSTALLING LOGS, LAVA ROCK AND GLOWING EMBERS
Note: 36" models shown. Logs will vary slightly for 32" models.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with fireplace.
Open louvers, remove screen, unlock door latches, and open glass door. See steps 1 and 2 of Removing/Replacing Glass Door, page 22. Install logs according to instructions for fireplace model numbers.
1.Place log #1 (rear log) on top of grate. Make sure the notches in the bottom of the log fit over the grate (see Figure 45).
2.Rest log #2 (large front log) on the pins on the front part of the grate (see Figure 46).
1
Rear Brick Panel
Figure 45 - Installing Log No. 1
Figure 43 - Installing Rear Brick Panel
2
Top Brick Panel
((V)T36 Series
Only)
Left Side
Brick Panel
Figure 46 - Installing Log No. 2
Figure 44 - Installing Left Side and Top Brick Panels
For more
visit www.
.com
108661
