Venting Installtion, Continued, Flashing Installation

FINISHING YOUR CHIMNEY SYSTEM

Flashing Installation

Storm Collar Installation

Terminations

VENTING INSTALLTION

Continued

Flashing Installation

Determine the flashing to be used with the roof opening chart, page

11.Slide flashing over pipe until base is flat against roof. Replace as many shingles as needed to cover exposed area and flashing base. Secure in position by nailing through shingles. DO NOT NAIL

THROUGH FLASHING CONE.

	Storm Collar
		Chimney Pipe
	Flashing	Overlap
		Overlap
	Nail Only Outer	Shingles
	Nail Only Outer	Top and
	Perimeter of	Top and
	Perimeter of	Sides
	Flashing	Sides
	Flashing	Only
		Only

Terminations

The fireplace system must be terminated with the listed round top or chase terminations. In any case, refer to the installation instructions supplied with the terminations.

The terminations approved for this fireplace are RTL-10DM, which can be used for flashing, or chase and ETL-10DM for chase style termination only. Figure 28 shows an RTL-10DM round top termination.

CAUTION: Do not seal openings on the rooftop flashing. Follow the installation instructions pro- vided with the termination being used.

Underlap Shingles

At Bottom

Figure 26 - Flashing Installation

Storm Collar Installation

Place storm collar over pipe and slide down until snug against the open edge of the flashing (see Figures 26 and 27). Apply waterproof caulking to all seams and notches around storm collar and also at base around shingles.

Chimney Pipe

Caulk

Stainless

Inner Flue

Pipe

Secure

Termination

To Outer

Pipe With

3 Screws

Overlap Shingles

(Top and Sides)