Cisco Systems OL-6157-01 manual Installing the Switch on a Wall, Mounting the Switch Under a Desk

Chapter 2 Installation

Installing the Switch

Step 7 Place the switch onto the mounting screws and slide the switch forward until it locks in place, as shown in Figure 2-4.

Figure 2-4 Mounting the Switch Under a Desk
1	4

2

	SERIES
	2940	atalystC
			DPS
			LXPD
			TA TS
		3	ST YS
1	Desktop	3	Slides on this way
2	Screws	4	Wall

89856

Installing the Switch on a Wall

Follow the steps in this section to install the switch to a wall:

Note The switch can be wall-mounted with the front panel facing up or down. The steps in this section show how to mount the switch with the front panel facing down (as shown in Figure 2-5 on page 2-10and Figure 2-6 on page 2-11.) If you want to mount the switch with the front panel facing up, rotate the screw template 180 degrees.

Step 1 Locate the screw template. The template is used to align the mounting screw holes.

Step 2 Position the screw template so that the two side-by-side slots face toward the ceiling, as shown in Figure 2-5. This ensures that the power cord faces toward the floor after they are connected.

For the best support of the switch and cables, make sure the switch is attached securely to a wall stud or to a firmly attached plywood mounting backboard.

Note Do not attach the screw template to the wall yet.

Catalyst 2940 Switch Hardware Installation Guide

OL-6157-01 2-9