Cisco Systems OL-6157-01 manual Connecting to an SFP Module, Installing the Switch Magnet Mount

Chapter 2 Installation

Connecting to an SFP Module

Installing the Switch (Magnet Mount)

To mount a switch by using the magnet, follow these steps:

Step 1 Place one side of the magnet against the bottom of the switch, as shown in Figure 2-7

Figure 2-7 Mounting the Switch with a Magnet

1

2

SERIES
2940	Catalyst

3

1 Desk 3 Switch

2Magnet

Step 2 Mount the magnet and switch on a metal surface.

DPS XLPD TA S TSYS

93242

Connecting to an SFP Module

This section describes how to connect to an SFP module. For instructions about how to install or remove an SFP module, see the Cisco Small Form-Factor Pluggable Modules Installation Notes (order number DOC-7815160=) and to the documentation that came with your SFP module.

Caution Do not remove the rubber plugs from the ports on fiber-optic SFP modules or the rubber caps from the the fiber-optic cable until you are ready to connect the cable. The plugs and caps protect the SFP module ports and cables from contamination and ambient light.

Before connecting to an SFP module, be sure that you understand the port and cabling stipulations in Table 1-2and in the “SFP Module Slot” section on page 1-4. See Appendix B, “Connectors and Cables,” for information about the LC on the SFP modules for fiber-optic connections.

Catalyst 2940 Switch Hardware Installation Guide

2-12 OL-6157-01