Cisco Systems OL-6157-01 manual Verifying Switch Operation

Chapter 2 Installation

Verifying Switch Operation

•Regulatory Compliance and Safety Information for the Catalyst 2940 Switch (order number DOC-7816656=)

•Product ownership registration card

If you want to connect a terminal to the switch console port, you need to provide an RJ-45-to-DB-25 female DTE adapter. You can order a kit (part number ACS-DSBUASYN=) with that adapter from Cisco.

You can connect a 100BASE-FX port to an SC port on a target device by using one of the MT-RJ fiber-optic patch cables listed in Table 2-1. Use the Cisco part numbers in Table 2-1to order the patch cables that you need.

Table 2-1 MT-RJ Patch Cables for 100BASE-FX Connections

Type	Cisco Part Number
1-meter, MT-RJ-to-SC multimode cable	CAB-MTRJ-SC-MM-1M
3-meter, MT-RJ-to-SC multimode cable	CAB-MTRJ-SC-MM-3M
5-meter, MT-RJ-to-SC multimode cable	CAB-MTRJ-SC-MM-5M
1-meter, MT-RJ-to-ST multimode cable	CAB-MTRJ-ST-MM-1M
3-meter, MT-RJ-to-ST multimode cable	CAB-MTRJ-ST-MM-3M
5-meter, MT-RJ-to-ST multimode cable	CAB-MTRJ-ST-MM-5M

Verifying Switch Operation

Before installing the switch, you should power on the switch and verify that it passes POST as described in the getting started guide.

The System LED turns amber if the POST fails. If the POST fails, see Chapter 3, “Troubleshooting,” to determine a course of action.

Catalyst 2940 Switch Hardware Installation Guide

2-4 OL-6157-01