Cisco Systems OL-6157-01 Installing the Switch Under a Desk, Mounting the Switch on Top of a Desk

Chapter 2 Installation

Installing the Switch

Step 7 Place the switch onto the mounting screws and slide the switch forward until it locks in place, as shown in Figure 2-2.

Figure 2-2 Mounting the Switch on Top of a Desk

SYST
STAT	1x	2x
DPLX			3x
SPD
	MODE

1

4x	5x
		6x
			7x
				8x
					Catalyst
				1	2940	SERIES

2

4

3

89858

1	Slides on this way	3	Desktop
2	Screws	4	Wall

Installing the Switch Under a Desk

Follow these steps to install the switch under a desk:

Step 1 Locate the screw template. The template is used to align the mounting screw holes and is also used as a guide to make sure the screws are installed under the desk with proper clearance.

Step 2 Position the screw template underneath the desk so that the two side-by-side slots face the front of the desk, as shown in Figure 2-4. This ensures that the power cord faces the rear of the desk after the switch is installed.

Note Do not attach the screw template to the desk yet.

Catalyst 2940 Switch Hardware Installation Guide

OL-6157-01 2-7